PYLE Audio PSW116MF1 manual Wooden wall

Hardware List: Actual parts appearance and the quantity may different with illustrated.

	2	UP
UP

UP

After determining the height of stand, follow the installation instructions in below to install wall mount to different kinds of wall -wooden, concrete.

Wooden wall:

UP

3

4

1

Us i n g a a w l o r n a i l t o m a k e where the nails are located, as shown as fig.2b. Distance between two nails for fixing wall mount must not less than 12”. Pre-drill these holes with a 5mm drill bit to at least 40mm in deep hole. Please make sure these holes are

level and located at center. Use wall mount as a template to mark the location of other three holes and drill the same holes. Fix the wall mount to the wall with 4 long bolts(J) and washers(L).

Concrete wall:

Using the wall mount as template to mark 6 holes location on the wall. Three holes are located at the top row of the slots and three more are located at the bottom row. The outer holes must be fall to the left and right of the two holes in the middle of the

mount. Please make sure these holes are level and at least 6” between any two lines. Pre-drill these holes with a 10mm drill bit to at least 50mm deep hole. Insert Wall

A-H I J K L M

anchors(K) into each of these holes. Attach the wall mount to the wall using 6 Long bolts(J) and washers(L).

ID	Qty	Description
1	1	Wall mount
2	2	Long Bracket
3	2	Short Bracket
4	4	Safe bolt
A	4	M4×12mm bolt
B	4	M4×16mm bolt
C	4	M5×16mm bolt
D	4	M6×16mm bolt
E	4	M8×16mm bolt

ID	Qty	Description
F	4	M5×36mm bolt
G	4	M6×36mm bolt
H	4	M8×36mm bolt
I	4	Square washer
J	6	Long bolt
K	6	Wall anchor
L	6	Long bolt washer
M	4	Spacer

				1
		L	J
			Balance-adjusting
Fig	2b		Fig	2c

Using balance-adjusting system on the plate, make sure whether wall plate is installed balance. If not, then slide the wall plate let pointer level in the center position.

-2- -7-