OPERATION
BASIC OPERATION
SWITCHING ON/OFF THE UNIT AND ILLUMINATING
Press PWR/ILL button on the front panel or POWER/ILL button on the remote control to turn on the unit. When system is on,press PWR/ILL or POWER/ILL button shortly to control the brightness of VFD. Press the button for several seconds to turn off the unit.
FACEPLATE RELEASE
Press OPEN button on the front panel to detach the removable faceplate.
SOUND ADJUSTMENT
Press SEL button on the front panel of the unit or on the remote control to select the desired adjustment mode.
The adjustment mode will change in the following order:
VOL |
| BASS |
| TRE |
| MID |
| BAL |
| FAD |
(Volume) | (Bass) | (Treble) |
| (Middle) |
| (Balance) |
| (Fader) | ||
By pressing the VOL+/- buttons on the front panel or VOLUME +/- buttons on the remote control, it is possible to adjust the desired sound quality.
SET THE CLOCK
Press the DISP button on the front panel or DISPLAY button on the remote control, the clock is shown on the display. Then hold down the DISP button or DISPLAY button until the clock flashes. Then press 
button on the front panel or 
button on the remote control to change minutes;
press 
on the front panel or 
button on the remote control to change hours.
MUTE
Press and hold MUT/ENT button on the front panel for several seconds or press MUTE button on the remote control to mute down the sound instantly. Press it again to resume sound output.
EQUALIZATION
Press EQ button on the remote control to turn on equalization function and to select desired audio mode. There are five kinds of mode as below:
FLAT 
CLAS 
POP 
ROCK 
DSP OFF 
SUBWOOFER
Press MODE (SW) button on the front panel or on the remote control for several seconds to toggle
MODE SELECTION
Press MODE button on the front panel of the unit or MODE button on the remote control to select among radio, disc (DVD/VCD/CD/MP3) play mode, CDC mode and AV IN mode.
VACUUM FLUORESCENT DISPLAY Exhibit current frequency and activated functions on the display of the front panel.
FLASHING LED
If the front panel does not install in the main unit, the LED will be flashing.
REMOTE SENSOR
Point the remote control handset to the remote sensor IR. Press the function keys on the handset to control the system.
RESET FUNCTION
RESET button must be activated with either a ballpoint pen or thin metal object. The RESET button is to be activated for the following reasons:
-Initial installation of the unit when all wiring is completed.
-All the function buttons do not operate.
-Error symbol on the display.
Note: if press RESET button, the unit can’t work yet, please use a cotton swab soaked in isopropyl alcohol to clean the socket on the front panel.
15