OPERATION
BASIC OPERATION
SWITCHING ON/OFF THE UNIT
Press any button on the front panel (except 
button and 
button) or POWER button on the remote control to turn on the unit. When the unit is on, press PWR button on the front panel or POWER button on the remote control to turn off the unit.
FACEPLATE RELEASE
Press 
button on the front panel to detach the removable faceplate.
SOUND ADJUSTMENT
Press SEL button on the front panel of the unit or on the remote control to select the desired adjustment mode. The adjustment mode will change in the following order:
VOL |
| BASS |
| TRE |
| MID |
| BAL |
| FAD |
(Volume) | (Bass) | (Treble) |
| (Middle) |
| (Balance) |
| (Fader) | ||
By pressing the VOLUME
/VOLUME
buttons on the front panel or VOLUME +/- buttons on the remote control, it is possible to adjust the desired sound quality.
SUBWOOFER
Press and hold MOD (SW) button on the front panel or MODE (SW) button on the remote control for several seconds to toggle
SET THE CLOCK
Press the DISP button on the front panel or DISPLAY button on the remote control, the clock is shown on the LCD display.
Then hold down the DISP button or DISPLAY button until the clock flashes.
Then press CH/TUN/TRK 
button on the front panel or 
button on the remote control to change minutes; press
CH/TUN/TRK 
on the front panel or 
button on the remote control to change
hours.
MUTE
Press and hold ENT/MUT button on the front panel for several secounds or press MUTE button on the remote control to
mute down the sound instantly. Press it again to resume sound output.
EQUALIZATION
Press EQ button on the front panel or on the remote control shortly to turn on equalization function and to select desired audio mode. There are five kinds of mode as below:
FLAT 
CLAS 
POP 
ROCK 
DSP OFF 
MODE SELECTION
Press MOD button on the front panel or MODE button on the remote control to select among radio, disc (DVD/VCD/CD/MP3) play mode, and AV IN mode.
LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated functions on the display of the front panel.
FLASHING LED
If the front panel does not install in the main unit, the LED will be flashing.
REMOTE SENSOR
Point the remote control handset to the remote sensor RX. Press the function keys on the handset to control the system.
RESET FUNCTION
RESET button on the housing must be activated with either a ballpoint pen or thin metal object. The RESET button is to be activated for the following reasons:
-Initial installation of the unit when all wiring is completed.
-All the function buttons do not operate.
-Error symbol on the display.
Note: if press RESET button, the unit can’t work yet, please use a cotton swab soaked in isopropyl alcohol to clean the socket on the front panel.
15