Esoteric UX-1 owner manual Important for U.K.Customers, ① For U.S.A

Page 3

This product has been designed and manufactured according to FDA regulations “title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968“, and is classified as class 1 laser product. There is not hazardous invisible laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings.

The label required in this regulation is shown .

For U.S.A.

Optical pickup :

 

Type

: GH20707A2A

Manufacturer

: SHARP CORPORATION

Laser output

: Less than 1mW on the objective lens

Wavelength

: 788±5 nm (CD), 650±10 nm (DVD)

 

 

IMPORTANT (for U.K.Customers)

DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer.

If nonetheless the mains plug is cut off, remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply.

If this product is not provided with a mains plug, or one has to be fitted, then follow the instructions given below:

IMPORTANT. The wires in this mains lead are coloured in accordance with the following code:

GREEN-AND-YELLOW: EARTH

BLUE : NEUTRAL

BROWN: LIVE

WARNING: This apparatus must be earthed.

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug proceed as follows:

The wire which is coloured GREEN-and-YELLOW must be connected to the terminal in the plug which is marked by the letter E or by the safety earth symbol or coloured GREEN or GREEN-and-YELLOW.

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.

When replacing the fuse only a correctly rated approved type should be used and be sure to re-fit the fuse cover.

IF IN DOUBT — CONSULT A COMPETENT ELECTRICIAN.

VARING: APPARATEN INNEHÅLLER LASER KOMPONENT MED STRÅLNING ÖVERSTIGANDE KLASS 1.

“ADVARSEL: USYNLIG LASERSTRÅLING VED ÅBNING NAR SIKKERHEDSAFBRYDERE ER UDE AF FUNKTION. UNDGÅ UDSAETTELSE FOR STRÅLING”

“VAROITUS! SUOJAKOTELOA EI SAA AVATA. LAITE SISÄLTÄÄ LASERDIODIN. JOKA LÄHETTÄ (NÄKYMÄTÖNTÄ) SILMILLE VAARALLISTA LASERSÄTEILYÄ”.

ADVARSEL: USYNLIG LASERBESTRÅLING NÅR DENNE DELEN ER ÅPEN OG SIKKERHETSSPERREN ER UTKOBLET UNNGÅ UTSETTELSE FOR STRÅLING.

ENGLISH

3

Image 3
Contents DVD/DVD-A/SACD/CD Player For U.S.A Important Safety Instructions① For U.S.A Important for U.K.CustomersContents Features Conventions about This Manual Placement of the unitBefore Use What’s in the boxRestoring factory settings Changing the Color System NTSC/PALAbout MOD.Modulation PAL Discs Type of Discs That Can be Played on This SystemSacd Example of Icons used on DVD discs Following discs cannot be played with this unitTV Monitor Connection to a TVVideo output terminal DVI-D video output terminalD1/D2 video output terminals component Component video output terminalsDecoder-equipped amplifier Connections to an amplifier, etcStereo amplifier Surround amplifierAnalog audio output terminals Word sync connectorSignal GND connection Power cord receptacleFront panel features Front panel display Understanding the remote control unit How to insert the batteries On-screen menu PlaybackOpening and closing the tray Pausing playback freezing the pictureResume mode Stopping playbackSelecting the playback area Selecting groups and titlesSkipping playback Selecting a chapter or trackTitle, group, disc repeat Repeat modeFast scanning Chapter and track repeatWhen selecting tracks from a DVD audio disc Programmed playbackFinish the programming by pressing Play Clearing the whole program Changing camera angleClearing the last track from the list Adding tracks to the listFrame advance Slow motion/frame advanceSelecting audio Slow motionDisplay dimming Use the FL Dimmer button to cycle between these settingsSelecting subtitles Lip syncDVI output aspect ratio DVI outputDVI output format DVI levelAnalog sound output Clock ModeDown mode Turning video on and offDVD video stopped, on-screen display Changing the display modeDVD video playback main unit display DVD video playback on-screen displaySACD/CD/video CD stopped, main unit display DVD audio playback on-screen displayDVD audio stopped, on-screen display SACD/CD/video CD playback main unit displayEnter the menu item with the right cursor button Settings introductionExit the setup mode by pressing Setup once more Use the cursor buttons to navigate the menusCD Digital Direct Settings AudioAnalog output settings Digital output settingsGroup playback mode DVD audio Audio DRC Dynamic Range ControllingDownmix Enter Settings VideoVideo adjustment Progressive scan settingDisplaying subtitles Settings LanguageAudio language selection Subtitle language selectionLanguage Code List Settings General/Speaker setup Speaker SizeSpeaker distance Digital output formats Settings GeneralSpeaker levels Test tone lengthSettings General/Video Out TV screenVideo output Closed captioning Still modeComponent video output PAL-NTSC conversionParental Control Settings General/DisplayPlaying a controlled disc Setting the level of controlResetting the password Country CodeTroubleshooting Maintenance Beware of condensationWRD Unlck Specifications English Block DiagramTeac Corporation