Daewoo SD-8800P, SD-8500P Initial Installation, Setting time and date Setting up the player

Initial Installation

■Switch the TV on.

■You can also start "AUTO SET" in the SETUP "PR PRESET" "AUTO SET".

■To tune in new stations (manual tuning) and enter station names see page 25-26.

Setting time and date / Auto clock

Setting time and date

Setting up the player

■Press [VCR] button on the remote control to change into VCR Mode and follow the procedure

1	You should see this picture the first time you switch on the TV
	and player.

2	OK for "AUTO SET!".
	"AUTO SET" tunes in all the stations you can receive in your
	country and sorts them in an order common for your country.
	Clock is automatically set.
3	If other stations are positioned on near the current RF OUTPUT
	CH, the guide message appears automatically.

AUTO SET

OK:CONFIRM SETUP:END

CH 25

PLEASE WAIT...

	SETUP:END
RF OUTPUT SET
CURRENT	CH 52

below.

1	Call the player’s "SETUP",
	choose "VCR SETUP", then "CLOCK SET".

2	Move to the position you want to change and type in the
	new values.
	Wait a few seconds after typing a one-digit number.

Store with [OK] button and exit with [SETUP] button.

CLOCK SET

TIME - - : - -

DATE - - / - - /- - - -

0-9:SETUP (HOUR)

</>:CORRECT SETUP:END

CLOCK SET

TIME 06:05

DATE 08/06/2003(SUN)

0-9:SETUP (HOUR) </>:CORRECT

OK:CONFIRM SETUP:END

Basic Operation

	The player recommends the optimal RF OUTPUT CH number
	automatically.
4	Press the [OK] button to confirm the recommended PR.
	Should you wish the stations to have the same numbers as those

used on the TV, follow the instructions in "Sorting programme locations" on page 26.

Otherwise ...

exit the basic installation function and enjoy your player.

RECOMMENDED CH 54

0-9:SELECT(21-69)

OK:CONFIRM SETUP:END

IMPORTANT!

PLEASE CHANGE THE TV CH TO 54.

MANUAL SET

PR01 BBC1	PR08 SKYS
PR02 BBC2	PR09 MTVE
PR03 ITV	PR10 P-10
PR04 CHA4	PR11 P-11
PR05 SKY1	PR12 ----
PR06 SKYN	PR13 ----
PR07 SKYM	PR14 ----

PR+/-:SELECT

OK:CONFIRM SETUP:END

Setting Auto clock

■Auto Clock is only available for models with the VPS/PDC function (see page 27).

Some broadcasting stations may send the time and date along with the VPS/PDC data. The video will automatically use this time and date during the initial setting up procedure during normal use, and every time you switch the video off at the mains. If you find that this time and date is incorrect you can remove this feature by following the steps below changing it to the OFF mode, you will then have to manually set the time and date, see above.

VCR SETUP		AUTO CLOCK
CLOCK SET		ON
RF OUTPUT SET
16:9 SET		OFF
OSD ON/OFF
AUTO CLOCK
PR+/-:SELECT		PR+/-:SELECT
OK:CONFIRM	SETUP:END	OK:CONFIRM	SETUP:END

•If you don´t see this picture, because you don´t use a SCART cable, search this picture now (CH 52) with the station tuning functions of your TV set (see its user manual).

•	In case of interference problems on CH 52, type in an
	other transmission channel between 21 and 69 using
	the number buttons.

But use the optimum CH number first!

18 19