Timer Recording
■For timer recordings, clock, date, and stations must be set correctly.
■Load a cassette with its safety tab in place and with sufficient free space for the recording.
Timer recording using VideoPlus (SD-9500P&SD-9800P only)
| Call the VideoPlus menu by pressing PROGRAM on the |
1 | remote control. |
From your TV magazine, type in the number next to the | |
programme you want to record ... | |
| ... and confirm. |
|
|
| Decide if you want to record "ONCE", "WEEKLY" or "DAILY"... |
2 | ... and confirm. |
|
|
| If you wish to make changes: |
3 | Move to the position you want to change using the [ / ] |
Changebuttons. the setting using the [ / ] or [number] buttons. If |
all setting are ok, press [ok], till you see “OK: CONFIRM” in the bottom line.
Confirm.
Switch your player off.
VIDEOPLUS
0-9:VIDEOPLUS NUMBER < :CORRECT
OK:CONFIRM SETUP:END
HOW OFTEN DO YOU WANT TO RECORD THIS PROGRAM?
ONCE WEEKLY(ONCE A WEEK)
PR+/-:SELECT
OK:CONFIRM SETUP:END
TIMER PROGRAM (ONCE)
PR | 03 |
START TIME | 21:20 |
END TIME | 22:20 |
START DATE | 14/06(SAT) |
TAPE SPEED | SP |
VPS/PDC | ON |
| |
</>:CORRECT |
|
OK:CONFIRM | SETUP:END |
VCR Operation
•VPS/PDC is a service provided by some stations to enable you to perform timer recordings precisely even if the broadcaster delays the start time of the programme slightly. The time you enter is the VPS/PDC time so this must be correct. Not all stations offer VPS/PDC, in which case the player will start at the time you enter and not the actual start time of the programme. If you wish to start recording at a specific time without it being adjusted by the VPS/PDC system in the event of a delay, switch VPS/PDC off otherwise the player will not record.
•If you don’t have the VideoPlus numbers see next page for the normal timer.
•If you have made a mistake, move back to the relevant position with the [<] button and change the setting.
•If there is no programme location displayed under “PR” in the change menu, the player doesn’t yet know the location number for the programme you want. Type it in and this will be stored to enable recordings.
•If you wish to record from a satellite receiver, select under “PR” the satellite programme location or AV (1/2) (depending on the connection with the antenna cable or the
•Should programming overlap, you get a warning.
•To cancel the recording press the 
button (stop) more than 5 seconds.
•VideoPlus is a trademark applied for by Gemstar Development Corp.. The VideoPlus system is manufactured under license from Gemstar Development Corporation.
27