PROGRAMMING THE REMOTE CONTROL
The HDTV Monitor is remote control is
1. Confirm that the external component is plugged in and turned off.
2. Find your component’s list of code numbers from the manufacturers Code List. (Refer to Component Codes)
3. Press and hold the “MODE” button (CATV, VCR) for the component you are setting up until the Mode selection button flashes.
4.Enter the
5.Press the “Mode” button, and then, LED lamp will blink three times and go out.
NOTE : Your component may not be compatible with the HDTV Monitor’s remote control. If this happens, you have to use your component’s own remote control to operate it.
56