STAND ASSEMBLY ___________
NOTE: Skip these steps if you are wall mounting the TV.
1Place HDTV face down on a padded or cushioned flat surface to protect the screen and finish.
2Carefully insert the stand base to the bottom of the HDTV and secure the base by inserting 4 screws as indicated in the diagram below.
NOTE: Stand base screws are located in the literature package.
3Position the HDTV on a firm and flat surface with adequate space for proper ventilation.
WALL MOUNTING (OPTIONAL)
Wall mounting of the HDTV must be performed by a skilled person.
If stand base disassembly is required:
1Place HDTV face down on a padded or cushioned flat surface to protect the screen and finish.
2Remove the four (4) screws securing the foot stand. CAUTION: Hold the stand firmly as you remove the last screw.
Use the screws you would use to attach the stand base to secure the HDTV to a wall mounting kit.
NOTE: Wall mounting kit is not included.
VESA standard interface: 400 x 400
Mounting screws measurements:
M6 (6mm) Diameter,
GETTING STARTED
BATTERY INSTALLATION
Install two (2) “AAA” batteries in the remote control. (Not included)
To ensure safe operation, please observe the following precautions:
•Replace both batteries at the same time. Do not use a new battery with a used battery.
•There’s a risk of explosion if a battery is replaced by an incorrect type.
•Do not expose the Remote Control unit to moisture or heat.
•Be sure to match the “+” and
ANTENNA CONNECTION FOR OFF-AIR SIGNALS OR CABLE
Hook up your antenna or your cable service to the HDTV’s ANT terminal with the use of a 75 OHM coaxial cable.
NOTE: Keep your indoor antenna at least 3 ft. away from the television set and any other electronic equipment.
ANTENNA
ANALOG / DIGITAL
ANTENNA IN
CABLE
Wall Mounting
Inserts
The tuner in this HDTV can receive:
• Digital and Analog off air signals from an antenna
• Analog or ClearQAM cable channels from a direct Cable TV connection.
Need help? www.sanyoctv.com 