Sanyo LCD-19E30A, LCD-42E30FA, LCD-26E30A Troublesheeting, Problem Try these Solutions, No Power

Page 38

APPENDIX

TROUBLESHEETING

Before calling your dealer or service center for assistance, check the matters below once again.

1.Make sure you have connected LCD TV to your equipment as described in the section “CONNECTING LCD TV”.

2.Check cable connection. Verify that all external equipment and power cords are properly connected.

3.Verify that all power is switched on.

4.If LCD TV still does not produce an image, re-start the external equipment.

5.If the image still does not appear, unplug LCD TV from the external equipment and check the external equipment. The problem may be with your graphics controller rather than with LCD TV. (When you reconnect LCD TV, remember to turn the external equipment and TV off before you power up LCD TV. Power the equipment back on in order of : LCD TV and external equipment.)

6.If the problem still exists, check the following chart.

Problem

 

 

Try these Solutions

 

 

• Plug this LCD TV into the AC outlet.

NO POWER

 

Press ON /STAND -BY button on SIDE Control or on Remote Control to open this LCD TV.

 

 

• Check POWER Indicator. If this indicator flashes, LCD TV has any trouble.

 

 

 

 

 

 

Check the batteries.

 

 

• Make sure nothing is between the Remote Receiver and the Remote Control.

Remote Control

 

Make sure you are not too far from LCD TV when using Remote Control.

does not work

 

• Maximum operating range is 16.4’(5m).

 

 

 

 

• Is direct sunlight or strong artificial light shining on LCD TV ‘s Infrared Remote Receiver?

 

 

 

Eliminate the light by closing curtains, pointing the light in a different direction, etc.

 

 

 

 

 

• Check the connection between the external equipment and LCD TV.

 

 

• When turning LCD TV on, it takes a few seconds to display the image.

No image

 

• Check the system that you select is corresponding with the external equipment or the video

 

 

equipment.

 

 

 

 

 

• Make sure the temperature is not out of the Operating Temperature (0°C ~ 40°C).

 

 

• Turn off power, then turn on again, re-start LCD TV.

 

 

 

 

 

• Check Audio cable connection from Audio input source.

No sound

 

• Adjust the Audio source.

 

Press VOLUME (+) button.

 

 

 

 

Press MUTE button.

 

 

 

 

 

• Dark or bright points of light (red, green, or blue) may appear on the screen. This is a

 

 

 

characteristic of the LCD panels, not a malfunction of the LCD TV.

 

 

• LCD panel is being produced with very high accuracy technology. There is 99.99% or more dot

There are tiny

 

 

pixel, but there is also 0.01 % or less of dot pixel lack or dot pixel that is constantly lighted. This is

black points

 

 

not defect.

and/or bright

 

Regarding LCD panel characteristic, it may occur picture remain (look like a mirror) when the

point on the TV

 

 

screen is changed if it displays same screen for a long time. Changing the picture or turn-off the

 

 

 

power supply may recover.

 

 

• Stripe pattern (more, interference stripes) may show up on the screen depend on the reflected

 

 

 

picture.

Ab normal

 

Adjust the value of colour.

colour of image!

 

Select different colour system.

 

 

 

 

WARNING :

High voltages are used to operate this LCD TV. Do not attempt to open the cabinet.

If the problem still persists after following all operating instructions, contact the sales dealer where you purchased LCD TV or the service center. Give the model number and explain the difficulty. We will advise you how to obtain service.

38

Image 38
Contents LCD TV To the Owner Read and Keep this OW NER’S Manual for Later USESafety Instructions LCD TVBefore Operation DisplaySnow World Colorful WorldGreen Field Water WorldPartnames and Functions IndicatorsSide Controls Panel Indicator FrontRGB D-SUB Back Terminals32/42 Connecting the AC Power Cord Connecting Outdoor AerialAudio Input Connecting a ComputerXGA Connecting Video Equipment AV OUTOperation of Remote Control Before OperationRemote Control Batteries Installation Operation RangePicture Menu TV/AV Mode Menu List Main Menu Channel MenuON-SCREEN Menu Audio MenuPC/HDMI Mode Menu List Main Menu Picture Menu Audio MenuChannel Selection Turning ON/OFF LCD TVSelecting Input Source Direct SelectionColour System Selecting Channel SourceSound System DisplayVirtual Surround Volume ControlECO StillAuto Aspect Ratio149 Text / TV Timmer SettingSports PictureText Subcode Text CancelText Index Text SizeMenu Operation TV/AV mode Tuning the TV for the First TimeSelection Mode Picture qualityPicture Normal NeutralBacklight Aspect Ratio3UHVVŻŹEXWWRQVWRVHOHFWVFUHHQVLH 3UHVVŻŹEXWWRQVWRVHOHFW³2II´RU³2Q´Cinema Mode Video 1/VIDEO 2 only 3UHVVŻŹEXWWRQVWRWXUQ³2Q´RU³2II´Audio Bass Boost For User mode adjustVitual Surround For User mode adjust Selectable Sound Digital onlyDual 1 or Dual 2 mode analog TV only Auto modeMono mode MTS analog TV onlyWill do full search, Are your sure? SetupCoutry/Region Full Search Digital TV only Menu Operation TV/AV mode Menu Operation TV/AV mode Menu Operation TV/AV mode 3UHVVŹEXWWRQWRGLVSOD\WKHEUHDNGRZQPHQX Manual Search Digital TV onlyChannel List Digital TVonly Sorting program positionAuto Tuning Analog TV only Favorite ChannelManual Adjust Analog TV only 3UHVVŹEXWWRQWRGLVSOD\WKHUHDNGRZQPHQXDisplaying the on-screen information Digital TVVGA Set PC only 3UHVVŻŹEXWWRQVWRDGMXVWYDOXHTimer FunctionCleaning LCD TV Function of Product Safety FeatureTroublesheeting Problem Try these SolutionsNo Power Specifications PAL/NTSC/NTSC4.43/NTSC 3.58/SECAM D/K , I, M , B/GSound speciality Vesa Configurations of VGA TerminalsVGA Table Component Video Timing Chart Safety Note Uninstalling Stand BaseWall Mounting optional Mounting screws measurementsPage Page Part No. HDJKTA3200I
Related manuals
Manual 47 pages 9.53 Kb Manual 47 pages 42.37 Kb