Sanyo DC-TS760 instruction manual Table of Contents, Precautions

TABLE OF CONTENTS

PRECAUTIONS	1
CONTROLS	2
REMOTE CONTROL	3
BASIC CONNECTIONS	4
ADDITIONAL CONNECTIONS EXAMPLES	7
SYSTEM CONNECTIONS EXAMPLES	8
BEFORE OPERATION	10

VARIOUS ADJUSTING	11
PLAYABLE DISCS	12
DISC PLAY	13
VARIOUS DISC PLAYING FUNCTIONS ....	14
MP3/WMA CD OPERATION	18
PICTURE CD OPERATION	19
INITIAL SETTINGS FOR DVD	20

LANGUAGE CODE LIST	22
LISTENING TO OTHER SOURCES	22
LISTENING TO THE RADIO	23
SLEEP TIMER OPERATION	24
MAINTENANCE	24
TROUBLESHOOTING GUIDE	25
SPECIFICATIONS	26

PRECAUTIONS

CAUTION

THIS PRODUCT CONTAINS A LOW POWER LASER DEVICE, TO ENSURE CONTINUED SAFETY DO NOT REMOVE ANY COVERS OR ATTEMPT TO GAIN ACCESS TO THE INSIDE OF THE PRODUCT. REFER ALL SERVICING TO QUALIFIED PERSONNEL.

-The apparatus shall not be exposed to dripping or splashing.

-No objects filled with liquids, such as vases, shall be placed on the apparatus.

-Do not use where there are extremes of temperature (below 5°C or exceeding 35°C) or where direct sunlight may strike it.

-Because of the DVD player’s extremely low noise and wide dynamic range, there might be a tendency to set the volume on the amplifier unnecessarily high. Doing so may produce an excessively large output from the amplifier which could damage your speakers.

-Sudden changes in the ambient temperature may cause condensation to form on the optical lens inside the unit. If this happens, take out the disc, leave the unit for about 1 hour, and then proceed to operate.

-When carrying the unit, be sure to remove any disc which may be inside and turn the power off. Wait at least 10 seconds, then unplug the mains lead from the AC outlet. Carrying the unit with a disc inside may damage the disc and/or the unit.

-Do not install this equipment in a confined space, such as a book case or built in cabinet.

-The unit is automatically set to the screen saver mode after approximately 15 minutes have elapsed under the stop or pause mode.

IMPORTANT

If the plug supplied with this equipment is not suitable for the socket outlets in your home it should be cut off and replaced with the correct type.

Disposal of Plug

If the non rewireable plug is to be cut off, the removed plug should be disposed of carefully as there is a shock hazard should the plug be inserted into a live socket.

Replacing Fuse

The detachable fuse cover must be replaced after changing the fuse. Only a 3A fuse should be used and should comply with BS1362 and

should carry the ASTA mark .

-Placing the unit in a well ventilated area is strongly recommended. Do not place any object on the top of the unit.

Do not block ventilation holes.

The cabinet of the unit warms up when it is used for a long time, but it is not a malfunction.

Important Information:

To connect this unit to a TV, TV must have a Video input socket or an EURO-AV/SCART socket. You cannot use an RF input socket or aerial terminal to connect this unit.

This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.

The wires in the mains lead are coloured in accordance with the following code;

BlueNeutral

BrownLive

The wires in the mains lead must be connected to the terminals in the plug as follows;

Wire colour	Plug terminal marking
Blue	N or Black or Blue
Brown	L or Red or Brown

Do not connect either wire to the earth terminal.

If the mains plug contains a fuse this should be 3A, if a plug without a fuse is used the distribution board fuse should not be greater than 5A.

The unit is not disconnected from the mains unless it is unplugged from the AC outlet.

1