Zenith Z52SZ80, Z44SZ80 warranty Power Cord Polarization

Page 2

Warning/Caution

Warning/Caution

WARNING/CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

WARNING/CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of suffi- cient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appli- ance.

WARNING/CAUTION:

TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.

POWER CORD POLARIZATION:

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

NOTE TO CABLE/TV INSTALLER:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the National Electric Code (U.S.A.). The code provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of the cable entry as practical.

REGULATORY INFORMATION:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

CAUTION:

Do not attempt to modify this product in any way without written authorization from LG Electronics. Unauthorized mod- ification could void the user’s authority to operate this product.

COMPLIANCE:

The responsible party for this product’s compliance is: Zenith Electronics Corporation

1-201-816-2000

Marked and Distributed in the United States by LG Electronics U.S.A., Inc. 1000 Sylvan Avenue, Englewood Cliffs, NJ 07632 http://www.zenith.com

2 DLP Projection TV

Image 2
Contents Installation and Operating Guide Warranty Power Cord Polarization Safety Instructions Important Safety InstructionsSafety Instructions Contents Introduction ControlsConnection Options Back Connection PanelFront Connection Panel Mini glossaryRemote Control Key Functions TV/VIDEOInstalling Batteries TV InputAnalog and Digital TV signals provided on cable InstallationAnalog and Digital TV signals provided on antenna External Equipment ConnectionsConnection Option VCR SetupAnalog and Digital TV signals provided on cable and antenna How to connect External A/V Source SetupDVD Setup How to useHdstb Setup Monitor Out SetupWhen the PC supports RGB How to connect PC SetupWhen the PC supports DVI How to connect Monitor Display Specifications RGB-PC or HDMI1/DVI ModeDigital Audio Output External StereoHdmi Cable sample ReferenceDTV Mode, the Supported TV Set Resolution Specification PC Mode, the Supported PC Resolution SpecificationOperation Turning on the TV just after installationTurning on the TV power cord is still connected Turning the TV OnTV Setup On-screen Menus Language SelectionChannel Edit Setup Menu OptionsEZ Scan Channel Search Channel Label Setup Main Picture Source SelectionVideo Menu Options Color Temperature ControlVideo Reset EZ PictureEZ SoundRite Audio Menu OptionsAudio Language EZ SoundFront Surround TV Speaker On/Off SetupStereo/SAP Broadcasts Setup On/Off Timer Setup Auto Clock SetupManual Clock Setup Time Menu OptionsSleep Timer Auto OffAspect Ratio Control Cinema 32 Mode SetupOption Menu Options Analog Broadcasting System Captions CaptionCaption/Text Digital Broadcasting System CaptionsCaption Option EZ DemoLock Menu Options Chip rating and categoriesParental Lock Setup Swapping the PIP/Twin Picture Selecting an Input Signal Source for PIP/Twin PictureWatching PIP/Twin Picture TV Program selection for PIPAdjusting Main and Sub Picture Sizes for Twin Picture Moving the PIP sub pictureBrief Info EZ Mute Adjustment for screen Position, Size, Phase, Reset OperationProgramming the Remote Programming Codes SAT DVD Or picture shaking Troubleshooting ChecklistHorizontal/vertical bars No output from one Poor TV input SignalPoor Video Signal Unusual sound fromExtended Absence Cleaning the ScreenCleaning the Cabinet Product Specifications Z44SZ80 Z52SZ80Page Zenith Electronics Corporation
Related manuals
Manual 48 pages 28.9 Kb