Transition Networks SSDTF1011-100, SSDTF1022-100 instruction manual Compliance Information

COMPLIANCE INFORMATION

UL Listed

C-UL Listed (Canada)

CISPR22/EN55022 Class A + EN55024

CE Mark

FCC Regulations

This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at the user’s own expense.

Canadian Regulations

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on the radio interference regulations of the Canadian Department of Communications.

Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

European Regulations

Warning

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Achtung !

Dieses ist ein Gerät der Funkstörgrenzwertklasse A. In Wohnbereichen können bei Betrieb dieses Gerätes Rundfunkstörungen auftreten, in weichen Fällen der Benutzer für entsprechende Gegenmaßnahmen werantwortlich ist.

Attention !

Ceci est un produit de Classe A. Dans un environment domestique, ce produit risque de créer des interférences radioélectriques, il appartiendra alors à l’utilsateur de prende les measures spécifiques appropriées

CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in damage to the public telephone network.

Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen einschliesslich der gegenseitigen Anerkennung ihrer Konformität.

T1/E1 Twisted-Pair Copper to Fiber

Media Converters

SSDTF10xx*-100

USER’S GUIDE

TRANSITION Networks SSDTF10xx-100 series media converters encode and decode T1 or E1 twisted-pair copper signals over duplex fiber-optic cable to extend the distance and transmission reliability of high speed T1 or E1 data traffic.

SSDTF1011-100

Provides an RJ-45 twisted pair copper	INPUT
connector for T1 or E1 signals and a set	9-12 VDC
of RX/TX ST connectors to 850 nm
multimode duplex fiber-optic cable.
		T!/E1FiberTPto ConverterMedia
SSDTF1012-100
Provides an RJ-45 twisted pair copper
connector for T1 or E1 signals and an
RX/TX ST connector to 1300 nm
singlemode duplex fiber-optic cable.
SSDTF1013-100	SSDTF1015-100 (long haul)
Provides an RJ-45 twisted pair copper	Provides an RJ-45 twisted pair copper
connector for T1 or E1 signals and an	connector for T1 or E1 signals and an
RX/TX SC connector to 850 nm	RX/TX SC-LHconnector to 1300 nm
multimode duplex fiber-optic cable.	singlemode duplex fiber-optic cable.
SSDTF1014-100	SSDTF1022-100 (long haul)
Provides an RJ-45 twisted pair copper	Provides an RJ-45 twisted pair copper
connector for T1 or E1 signals and an	connector for T1 or E1 signals and an
RX/TX SC-SMconnector to 1300 nm	RX/TX ST connector to 1300 nm
singlemode duplex fiber-optic cable.	singlemode duplex fiber-optic cable.

Trademark Notice

All registered trademarks and trademarks are the property of their respective owners.

Copyright Restrictions

© 2001, 2002 TRANSITION Networks.

All rights reserved. No part of this work may be reproduced or used in any form or by any means – graphic, electronic, or mechanical – without written permission from TRANSITION Networks.

Printed in the U.S.A. 33202.C

*In SSDTF10xx model designation, 10 represents the T1 or E1 RJ-45 connector;

xxrepresents the selectable fiber connector installed on the media converter.

SSDTF10xx in the Network . .	. . . . .2
Installation	. . . . .3
Operation	. . . . .7
Fault Isolation and Correction	. . . . .8
Cable Specifications	. . . . .9
Technical Specifications	. . . .11
Compliance Information	. . . .12