Transition Networks SSDTF1022-100 Installation, Operation, Install Cable, Status LEDs

Page 6

INSTALLATION (continued)

Install Cable

COPPER

T1 100 OHM (RJ-45 CONNECTOR)

1. Locate or build twisted-pair cables that are compliant with

OPERATION

After installation, the media converter should function without operator intervention.

Status LEDs

Use the status LEDs to monitor media converter operation in the network.

 

specifications on page 10, with RJ-45 plug connectors at both ends.

2.

Ensure that MDI/MDI-X switch is set according to network

 

conditions.

3.

Connect RJ-45 plug connector at one end of cable to media

 

converter RJ-45 jack connector.

SDC

Signal Detect/Copper - Steady LED

 

indicates twisted-pair copper link is up.

 

Flashing LED (once/second) indicates

 

transmitting on link if other link is down.

 

Flashing LED (5 times/second) indicates

 

All Ones detected on Link.

SDC SDF PWR

LOOP

4. Connect RJ-45 plug connector at other end of cable to network

equipment.

FIBER

1.Locate or build fiber cables that are compliant with specifications on page 9, with male two-stranded TX to RX connectors installed at both ends.

2.Connect cable with connector installed at TX location on media converter to RX location on attached device.

TX

TX

RX

RX

3.Connect cable with connector installed at RX location on media converter to TX location on attached device.

Power the Media Converter

1.Install power adapter cord at back of media converter.

2.Connect power adapter plug to AC power.

3.Verify that media converter is powered by observing illuminated LED(s).

SDF

Signal Detect/Fiber - Steady LED indicates fiber link is up.

 

Flashing LED (once/second) indicates transmitting on link if

 

other link is down.

 

Flashing LED (5 times/second) indicates All Ones detected on

 

Link.

P(o)W(e)R

Steady green LED indicates connection to external AC power.

Image 6
Contents Compliance Information SSDTF1011-100SSDTF10xx in the Network Technical SpecificationsFeatures TN PNSwitch-Selectable Functions Cable SpecificationsSwitch-Selectable Configurations Twisted-Pair Copper CableInstallation Cable SpecificationsIs the SDF Signal Detect/Fiber LED illuminated? Fault Isolation and CorrectionIs the PoWeR LED on the media converter illuminated? Is the SDC Signal Detect/Copper LED illuminated?Power the Media Converter InstallationInstall Cable Operation