Venturer PLV16198 Maintenance, Troubleshooting Guide, Cleaning the Unit, Symptom Cause and Remedy

MAINTENANCE

CLEANING THE UNIT

•Be sure to turn the unit off and disconnect the AC power cord before cleaning the unit.

•Wipe the unit with a dry soft cloth. If the surfaces are extremely dirty, wipe clean with a cloth that has been dipped in a weak soap-and-water solution and wrung out thoroughly. Then wipe it with a dry cloth.

•Never use alcohol, benzene, paint-thinner, cleaning fluid or other chemicals. Do NOT use compressed air to remove dust.

TROUBLESHOOTING GUIDE

SYMPTOM		CAUSE (AND REMEDY)
No power.		•	Make sure the AC power cord is connected.
		• The unit is not turned on.
The remote does not		•	Remove any obstacles between the remote and the unit.
function.		•	Use the remote near the unit.
		• Point the remote at the remote sensor on the unit.
T V		•	Replace the batteries in the remote with new ones.
Bad Picture (snow,		•	Check the location of the antenna and adjust it if necessary.
multiple	images,	•	Make sure the antenna cable is firmly connected.
distortion, blurry)		•	Make sure all input cables are firmly connected.
Black and	white	•	Check the PICTURE MENU within the TV SETUP MENU.
picture.		•	Check to make sure the program you are watching is broadcast in Color
			and not black and white.
No picture or sound.		•	Make sure the unit is plugged in and turned on.
		•	Make sure TV mode is selected.
		•	Try a new channel to check for possible station trouble.
		•	Make sure the antenna is connected properly.
		•	Increase the volume.
		•	Make sure the antenna or audio video source device is working properly.
		•	Make sure all cables are firmly connected.
		•	Check for local interference.
Colored patches of		•	Make sure there are no unshielded electrical devices nearby that are causing
picture.			interference.
		•	Turn the unit off for 30 minutes, then try it again.
			E - 17

Untitled-3 17 9/7/2007, 12:31 PM