QUICK INSTALLATION
When you turn on your television set for the first time, be sure to place it on a solid stable surface. To avoid danger, do not expose the TV to water, or a heat source (e.g. lamp, candle, radiator). Do not obstruct the ventilation grid at the rear and be sure to leave sufficient gaps around the unit as shown.
TURNING ON THE UNIT FOR THE FIRST TIME
The first time you turn on the unit, the unit will enter Setup mode. You can easily follow the prompt message on the screen to complete basic TV settings.
Make sure the RF aerial has been connected properly to the TV ANTENNA input jack on the rear of the system.
Proceed with auto scan ?
NoYes
:SELECT 
"ENTER":COMFIRM
1.Press the 
/ 
button to select Yes. Press the ENTER button to proceed with the initial setup.
PICTURE AUDIO | TIME SET UP PARENTAL TV |
Cable System | AUTO |
Start to Scan |
|
UP/DOWN 
ADJUST "MENU":EXIT
PICTURE AUDIO | TIME SET UP PARENTAL TV |
Antenna | CATV |
Auto Scan |
|
Auto Scan Add CH |
|
Channel Skip |
|
Channel No. |
|
Channel Label |
|
DTV Signal |
|
UP/DOWN 
ADJUST "MENU":EXIT
2.Use the 
/ 
button to select Antenna, then press the 
/ 
button to select Air or CATV.
PICTURE AUDIO |
|
| TIME | SET UP PARENTAL TV | |
| RF CH | : | 16 | ||
| Found | : | 0 | ||
|
|
|
|
|
|
PRESS <MENU> TO EXIT AUTO SCAN
3. Use the 
/ 
button to select Auto Scan, then press the 
button to enter auto scan menu. Use the 
/ 
button to select Start to Scan, and press the 
button to begin scanning (If you selected CATV on Step 2, you need to select Cable System before Start to Scan). The system will automatically start
to scan and preset all available TV channels.
4.After scanning has finished, the system will return to the first TV channel scanned.
E - 4
4 | 9/7/2007, 12:30 PM |