Instruction Manual
DVI Video Extender over CAT5 UTP
ST121UTPDVI / ST121UTPDVGB / ST121UTPDVEU
DE: Bedienungsanleitung - de.startech.com | Local Unit |
FR: Guide de l'utilisateur - fr.startech.com |
|
ES: Guía del usuario - es.startech.com |
|
IT: Guida per l'uso - it.startech.com |
|
NL: Gebruiksaanwijzing - nl.startech.com |
|
PT: Guia do usuário - pt.startech.com |
|
Packaging Contents
•1 x DVI Extender Local Unit
•1 x DVI Extender Remote Unit
•2 x Power Adapter
•1 x Instruction Manual
Remote Unit
System Requirements
•DVI enabled video source device (i.e. computer, PVR/DVR, etc)
•DVI enabled video display device (i.e. monitor, projector, etc)
•Available AC electrical out at local/remote locations
Preparing Your Site | Installation |
1.Determine where the local video source (i.e. computer) will be located and set up the device.
2.Determine where the remote display will be located and place/ mount the display appropriately.
3.If you are using surface cabling, ensure you have enough Cat5 unshielded twisted pair (UTP) Ethernet cabling to connect the Local Unit to the Remote Unit’s location, and that each end is terminated with a RJ45 Ethernet connector. The cabling should not go through any networking equipment (i.e. router, switch).
OR
If you are using premise cabling, ensure that the Cat5 unshielded twisted pair (UTP) Ethernet Cabling between the Local Unit and the Remote Unit has been properly terminated in a wall outlet in each location and there is a patch cable long enough to connect the Remote Unit and the Local Unit to their respective outlets. The cabling should not go through any networking equipment (i.e. router, switch).
1.Turn off the video source (i.e. computer) and the intended display device (i.e. monitor).
2.Position the Remote Unit near the intended display.
3.Position the Local Unit near the video source.
Please note that both units will require a power connection, so please ensure that each unit is situated near an available power outlet.
4.Connect the video source to the “DVI In” port on the rear panel of the Local Unit, using a
5.Connect the intended display to the “DVI Out” port located on the rear panel of the Remote Unit using a
6.Connect the Local Unit to the Remote Unit, using standard RJ45 terminated CAT5 cable (see Preparing Your Site).
7.Connect the power adapters (provided) to both Local and Remote Units.
8.Turn on the display device first, followed by the video source.
For the most
Manual Revision: 02/07/2012