Texas Instruments 8200IC, 8200IW, 8100CB manual Shutdown, Operation 3M Digital WallDisplay

Page 16

Operation

3M™ Digital WallDisplay

Shutdown

Press the On/Off Button on the bottom center panel of the 3M Digital WallDisplay unit.

The lamp will turn off and the projector arm will return to its housing. The On/Off Button will flash amber as the arm closes.

Note: There is a 30-second reset period before the On/Off Button will function again. During this period, the On/Off Button will flash red.

The fan will continue to run for approximately five minutes to cool the unit.

Note: If the 3M Digital WallDisplay will not be moved or disconnected, leave the Master Power Switch on for your convenience.

Do not turn off the Master Power Switch or unplug the power cord before pressing the On/Off Button. After the On/Off Button is pressed, the fan continues for approximately five minutes to cool the 3M Digital WallDisplay.

16	© 3 M 2003. All Rights Reserved.

Image 16

Contents Operator’s Guide This page intentionally left blank for printed version Contents Contents 3M Digital WallDisplay Service InformationAppendix Safety Precautions IntroductionThank You for Choosing 3M Intended UseIntroduction 3M Digital WallDisplay Product Safety Label IntroductionTrademarks PatentsSoftware and Copyright License Agreement 3M Digital WallDisplay Technical SupportVideo Signal Cables FCC Statement-Class aEEC Statement-Class a Instructions to UsersModel Identification and Differences Identify ModelModel Differences Model Number Model NameOptional Accessories Part Identification 3M Digital Wall Display Features System Setup Connecting to Various EquipmentOperation StartupShutdown Operation 3M Digital WallDisplayRemote Control Unit FeaturesForward Keypad Rear Keypad Installing or Replacing Batteries Digital Markers and Eraser Assembling Digital MarkersAssembling Digital Eraser Digital Markers and Eraser 3M Digital WallDisplayMenu System Menu NavigationColorful-Bright Slider Menu KeypadVolume Slider Warm-Cool SliderMute Menu Function Input Select Menu Reset All MenuMenu System 3M Digital WallDisplay Image Adj Sub-Menu Tools Sub-Menu Copyboard Mode Whiteboard Mode 8200IC onlyProjection Mode 8200IC only Using Copyboard ModeUsing Whiteboard Mode Installing eBeam Software on Your ComputerMinimum Requirements Apple MacintoshInstalling the Software WallDisplay as a Copyboard or Digital WhiteboardUsing Projection Mode Maintenance General MaintenanceLamp Usage Onscreen Lamp MessagesLamp Replacement Maintenance 3M Digital WallDisplayMaintenance Dispose of this lamp properly 3M Digital WallDisplay dealer replace a ruptured lampResetting Lamp Hours Replacing ProjectionScreen Troubleshooting Common Problems and SolutionsOnscreen Messages Message MeaningEBeam Software EBeam Hardware Detection/UseProblem EBeam Try the following See Proxy Server SetupServer. See Proxy Server Setup MeetingDialog box see Setting Pen Colors/Line Thickness. It Writing Data/CaptureChoose eBeam Hardware Detect eBeam Hardware EBeam HardwareTroubleshooting EFI Meeting Applet Microsoft Internet ExplorerNetscape Clear Memory Cache and Clear Disk CacheBackground Images See Loading an Excel Spreadsheet as a Background ImageService Information Parts and AccessoriesOptional Accessories Ordering Parts or Getting Information3M Digital WallDisplay Specifications AppendixResolution Refresh Rate Horizontal Frequency Input/Output Signal SpecificationsComputer Compatibility Appendix Printer CompatibilitySection Head Important Notice