Installation (cont.)
Attaching the Reflector to the Antenna
1.Starting from the right side, slide the Clip that is attached to the Reflector diagonally into the notch at the back of the Antenna. (See Fig. 4, 5)
2.Once the Clip is pushed in, slide it to the side so that it forms a 90 degree angle to the Antenna’s edge. (See Fig. 6)
3.Repeat steps 1 and 2 for all four Clips.
Installation
Attaching the Antenna with reflector to the Base
1.Route the 6’ Mini Coax Cable through the Base and screw it securely to the Antenna.
2.Slide the Antenna with Reflector onto the Base.
3.Using a screw driver slightly tighten the two screws, (see Fig. 7), to secure the Antenna to the Base.
Fig. 7 |
Connecting the SharpSh
oterTM
1.Connect the Mini Coax Cable that is attached to the Antenna to the Power Injector labeled “Antenna”.
2.Connect the 2’ Coax Cable from the Power Injector labeled “TV” to your HDTV or
3.Connect the 6’ Standard Coax Cable from the Power Injector labeled “Power” to the AC Adapter.
4.Plug in the AC Adapter to a standard AC outlet.
| 6’ Coax | |
| Cable | |
| $17(11$ | |
| 79 | |
2’ Coax | (5 | |
32: | ||
$17(11$ | ||
Cable | ||
79 | ||
| 32:(5 | |
Fig. 8 |
|
Fig. 6 |
Attaching Rubber Feet to the Base Remove the protective adhesive strip from the four rubber feet and apply them to the bottom of the antenna base.
Fig. 9 | Feet |
|
4
5 |