Winegard RM-DM61/DM55 Operations DO’S and DON’T’S, Suggested Setups for Multiple TVS, Do’S

Page 3

OPERATIONS DO’S AND DON’T’S

DO’S

1.Do check parking location for obstructions before raising antenna.

2.Do carefully raise, lower and rotate the antenna — if difficult, check for cause.

3.Do rotate slowly when searching for the satellite(s) and check fine tuning on TV set for proper adjustment.

4.Do lower antenna before moving vehicle.

5.Activate programming by calling programming provider for your receiver.

DON’T’S

1.Don’t move RV/Coach with the antenna in the UP position. This will VOID your warranty. This may also cause damage to your roof.

2.Don’t force the elevating crank up or down. Check for the cause.

3.Don’t rotate directional handle hard against stops.

4.Don’t apply paint on top of base plate or anywhere on the lift.

5.Don’t apply approved sealing compound on gear housing.

SUGGESTED SETUPS FOR MULTIPLE TVS

FIGURE 1

FIGURE 2

3

Image 3
Contents Parts Included Reflector dish Gasket WinegardOperation TroubleshootingTuning Antenna for the Best Picture Finding the SatelliteDON’T’S Suggested Setups for Multiple TVSOperations DO’S and DON’T’S DO’STrouble Shooting Things YOU Need Installation and AssemblyCable-entry plate Minimum 3 from mount base Mount travel bracket to roof 6-1/8 from base, , For RM-DM61/RM-DM55 only Inside Your RVDigital Elevation Sensor Roof Connections LENGTH, a If YOU are Using AN Exten³ Figure Cutting ShaftBack of RV Approximately From Travel PositionDirectional Handle Point toExploded Parts View RK-CEIL Parts ListInterior Hardware KITLnbf SpecificationsReplacement Parts Kits Page Return Authorization Policy