Receiver Setup for a Secondary Receiver

After completing setup on the main receiver, power on the secondary receiver. If using a new receiver, you will be guided through the setup by the Installation Wizard; turn the primary receiver to channel 101, and follow the on-screen steps on the secondary receiver. The primary receiver should remain on channel 101 for the duration of the initial setup. If using a receiver that is currently active or has been used previously, complete setup by doing a Check Switch test.

Note Every time the primary receiver toggles to a different satellite, a Check Switch test must be repeated.

1.Press “Menu” on your remote. Select option 6, “System Setup.”

2.Select option 1, “Installation” (see fig. 11).

Figure 11

3.Then, select option 1, “Point Dish” (see fig. 12).

5.Select “Test” (see fig. 14). The receiver will then run through a series of tests to install the proper satellite. The Check Switch test will install the satellite that the primary receiver is receiving signal from.

TIP Do not change channels on the primary receiver when configuring the secondary receiver. Changing channels on

the primary satellite when configuring the secondary receiver may interfere with the setup of the secondary receiver setup.

Figure 14

6.If a warning appears that fewer satellites have been found, select “Save”; then, select “Save” again (see fig. 15).

Figure 15

7.The test should result in a green ‘OK’ status for the satellite that has been installed (see fig. 16).

Figure 12

4.Select “Check Switch” (see fig. 13).

Figure 13

Figure 16

8.Then, exit out of the Point Dish menu. The receiver will begin downloading the Electronic Programming Guide.

9.Every time the primary receiver toggles to a different satellite, the steps above must be repeated.