Tripp Lite DWT2647XP owner manual 1b. Mount on Solid Brick and Concrete Block

1b. Mount on Solid Brick and Concrete Block

ø 10mm

(ø 11/32”)

1

Mark the exact location of mounting holes

2

Drill pilot holes

Concrete Anchor

D6 Washer

Anchor Bolt

Screw the wall plate onto the wall

WARNING

•When installing wall mounts on cinder block, verify the actual concrete thickness is at least 1-3/8” (35mm) for using the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally 1” (25mm) minimum from the side of the block. It is suggested an electric drill on a slow setting be used to drill the hole instead of a hammer drill to avoid breaking out the back of the hole when entering a void or cavity.

•Installers must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.

5

13-09-232-9332A2.indd 5 11/8/2013 2:08:59 PM