Palsonic DVDR160G instruction manual Setup MENU-AUDIO, Downmix

SETUP MENU-AUDIO

Downmix	ON			-- Downmix
				ON: when playing disks with 5.1 channels ,the left speaker
	OFF
				will output sound of left channel, and partial sound of centre
SPDIF Output
	RAM			and surround channels; the right speaker will output sound
	LPCM
				of right channel and partial sound of centre and surround
LPCM Output	LPCM 48K
				channels.
	LPCM 96K
				OFF: All 5.1 channels have audio output.
Dynamic Range	Full
				-- SPDIF Output
	3 / 4
	1 / 2			RAW: when the unit is connected with an amplifier
	1 / 4			by coaxial or optical, please enable this option. When
	Off			playing disk that recorded in Dolby Digital, DTS or MPEG
Speaker Setup
	OK	SPEAKER SETTING	On	format, the unit will send out digital sound code through
		Centre		coaxial or optical output. The amplifier must hold Dolby
			Off
				Digital, DTS and MPEG decoder.
		Rear	On
			Off	PCM: when this option is enabled, the unit will decode
		Subwoofer	On	sound code into PCM signal when playing disk in Dolby,
			Off
				DTS and MPEG format, and send out through coaxial or
		Centre Distance	Off
				optical output.
			0.3m
			0.6m	-- LPCM Output:
			1m	48K: the sampling frequency of LPCM digital audio output
			1.2m
				is 48KHz.
			1.5m
		Rear Distance	Off	96K: the sampling frequency of LPCM digital audio output
			1m	is 96KHz. The amplifier must support 96KHz decoding.
			2m	Note: LPCM refers to digital audio format without
			3m
				compression (no loss).
			4m
			5m
		Test Tone	OK
		OK
				Test Tone
				Test Control	All Circle
-- Dynamic Range:				Now Testing Front-left Speaker
					Front Left
It's used to adjust the dynamic range compression to increase				EXIT	Front Right
the Volume of small detailed audio when you watch movie of					Centre

large dynamic range with low volume and can't enjoy the small	Rear Left
	Rear Right
detailed audio. It helps you not to disturb the neighbour or
	Subwoofer
decrease the audio quality.
Speaker setup
Only when Downmix is "OFF", can you enter this setup.
-- Front Speakers
When speakers are set to "ON" . there's audio output from the terminal of the channel.
When speakers are set to "OFF" , there's no audio output from the terminal of the channel.
-- Centre Speakers
When speakers are set to "ON" , there's audio output from the terminal of the channel.
When speakers are set to "OFF" , there's no audio output from the terminal of the channel.
-- Rear Speakers
When speakers are set to "ON" , there's audio output from the terminal of the channel.
When speakers are set to "OFF" , there's no audio output from the terminal of the channel.
-- Subwoofer
When set in "On" , there will be signal sent out to Subwoofer output.
When set in "Off" , there will be no signal sent out to Subwoofer output.
-- Centre distance:
To delay the time of audio out from centre speaker.
-- Rear distance:
To delay the time of audio out from rear speakers.
-- Channel distance:
To select test audio signal of each channel output from unit.

15