Palsonic 6827G To watch a TV programme, Using the direct select buttons, Using the CH buttons

OPERATION

Channel selection

You can watch TV programmes being broadcast on the preset channels.

To watch a TV programme

You can select your desired TV program by one of the following methods.

Using the direct select buttons

To select a one-digit position number (0-9)
METHOD 1: Press the button and the screen displays "X- -", wait for 2	After 2	X--
seconds and the channel is selected.	seconds
METHOD 2: Press 0 button and the screen displays "0- -", then press 0 button		X
again, the screen displays "00-" then press the numbers. (The
period of two-press must be within 2 seconds).

To select a two-digit position number (10-99)

METHOD 1: Press these two numbers and the screen displays "XX -", (The period of two-press must be within 2 seconds). Wait for 2 seconds and the channel is selected.

METHOD 2: Press 0 button first, than press these two numbers, the screen displays "0XX", the channel is selected. (The period of two-press must be within 2 seconds).

To select a three-digit position number (100-255)

Press these three numbers and the screen displays "XXX" the channel is selected. (The period of two-press must be within 2 seconds).

NOTE: If the input number is over 255, the screen will remain at the current viewed program.

Using the CH buttons

Press CH to select lower position numbers;

CH to select higher ones.

Using the PREVIOUS channel button ()

X--

XX-

XX

X--

XX-

XXX

3

2

1

When there are no menus on the screen, pressing the button on the remote controller (below the

MENU button) can swap the current viewed channel with the previous one. For example, the channel you previously watched is 11, the present channel is 2, press the button, it will return to channel 11, press the button again it will return to channel 2.

11

2

Using the channel SCAN button

Press SCAN button, the set will scan the channels from first channel to higher channels one by one, every program will be displayed for about 3 seconds and then go on scanning until all programs are scanned over and then return to your former viewed program. During the scanning, press SCAN button again, the set will return to your former viewed program.

12