OPERATION
Channel selection
You can watch TV programmes being broadcast on the preset channels.
To watch a TV programme
You can select your desired TV program by one of the following methods.
Using the direct select buttons
To select a |
|
|
|
|
|
|
|
| |
METHOD 1: Press the button and the screen displays "X- |
| After 2 |
| |
seconds and the channel is selected. |
| seconds |
|
|
|
|
| ||
|
|
| ||
METHOD 2: Press 0 button and the screen displays "0- |
|
|
| X |
|
|
| ||
again, the screen displays |
|
|
| |
|
|
|
| |
period of |
|
|
|
|
To select a two-digit position number (10~99)
METHOD 1: Press these two numbers and the screen displays "XX
METHOD 2: Press 0 button first, than press these two numbers, the screen displays "0XX", the channel is selected. (The period of
To select a three-digit position number (100~255)
Press these three numbers and the screen displays "XXX" the channel is selected. (The period of
NOTE: If the input number is over 255, the screen will remain at the current viewed program.
Using the CH
buttons
Press CH
to select lower position numbers;
CH
to select higher ones.
Using the PREVIOUS channel button (
)
When there are no menus on the screen, pressing the 
button on the remote controller (below the MENU button) can swap the current viewed channel with the previous one. For example, the channel you previously watched is 11, the present channel is 2, press the 
button, it will return to channel 11, press the 
button again it will return to channel 2.
Using the channel SCAN button
XX-
XX
XX-
XXX
3
2
1
11
2
Press SCAN button, the set will scan the channels from first channel to higher channels one by one, every program will be displayed for about 3 seconds and then go on scanning until all programs are scanned over and then return to your former viewed program. During the scanning, press SCAN button again, the set will return to your former viewed program.
12