Yellow KEY, Auto-Search | Palsonic 3490 manual

NOTE:

The instruction with "#" symbol is only applicable when AV IN signal is NTSC system or the TV set is selected NTSC system.

1.When this menu is first activated, no bar display will be shown.

2.When RED key is pressed, the bar display appears in red to indicate the current level setting for Brightness. Activation of plus or minus (PR -/+ on local & remote key board) key will change the level for Brightness.

3.If GREEN key is pressed, the bar display changes to green colour to indicate the current level setting for Colour. The same principle applies to yellow for Contrast and BLUE for

*Tint.

To exit menu, press " /--" key. At local keyboard, press STANDBY key to exit menu.

YELLOW KEY

This key activates the installation menu as shown below: -

OSD

SEARCHUH

STORE01

FINE-TUNE

AUTOPROGRAM

Red

Green

Yellow

Blue

When this menu is first activated, no bar display will be shown. * In AV mode, the menu can not be activated.

AUTO-SEARCH

1.When RED key is pressed, the bar display appears in red colour to indicate that SEARCH is in operation and '>>' (red colour) appears as shown below: -

OSD

SEARCHVL

STORE>>

FINE-TUNE

AUTOPROGRAM

Red

Green '>>' in Red Yellow

Blue Red bar

2.It will search to the next available station and stop to allow user to key in the program . number to store by indicating '--' (red colour ).

3.The program number to be stored can be entered by direct number entry or PR -/+.

4.After two digit program number has been entered, the user can then press the GREEN key to store the signal to the desired program number. The program number which was in red will turn to green to indicate that STORE operation is completed.

5.During auto-search, only power on/off key is recognised, the rest of the keys are ignored. When tuning voltage reaches the end of one band, the system changes band and start to tune again after a delay of 400 ms.