NOTE: To select two digit channel, the second digit must be pressed within 2 seconds.
*PREVIOUS BUTTON (REMOTE CONTROL UNIT)
Pressing this button to select the channel that was tuned immediately before the one being watched. For example: If you are watching the program on channel 6, and the previous program you watched is on channel 15; then you can press the button to reach channel 15, press it again to return channel 6.
6 15
CHANNEL PRESET
. AUTO PRESET
1.Press the PSET (PRESET ON/OFF) button on the front panel. The current band and channel position will be displayed on screen (in green).
2.Press AUTO (AUTO PRESET) button, the appliance will search the signal of TV station in the order of VHFL, VHFH and UHF, as shown in the following, and memorise them from channel number 1 position.
VHFL 
VHFH 
UHF 
*During presetting, the green block turns into yellow.
The moving red block indicates the change of tuning voltage.
3.When presetting is over, the channel position is set to number 1 automatically.
4.Press PSET (PRESET ON/OFF) button to exit preset mode.
NOTE: During presetting, auto presetting will be cut off if any one of STAND BY button, PRESET ON/OFF button or AUTO PRESET button is pressed.
. MANUAL TUNING
1.Press PSET (PRESET ON/OFF) button to set preset mode.
2.Select a channel position.
*If “SKIP” displays on the screen, press "SKIP" button on the front panel to exit "SKIP" mode.
8 SKIP
llllllllllllll
SKIP
8 VHFH
llllllllllllll
3.Press and hold MANUAL TUNING button until your desired program appears.
VHFL 
VHFH 
UHF
MFT 
VHFL
VHFH 
UHF
5