Tuning In
3 Manual Search
If auto search can not preset the desired channels, or you want to preset the desired channels one by one with the preferred channel numbers, please make use of Manual Search.
3.1From the PRESET menu, press 
CH+/- to select PROGRAM item and use VOL+/- to select a program number.
PROGRAM | 001 |
SKIP | OFF |
BAND | |
FINE TUNE |
|
MANUAL SEARCH |
|
AUTO SEARCH | - - - |
CH.SWAP | |
CH TYPE | NEWS |
SEL. | SET |
Direct Channel select
Note: You can also use
To exit menu
To display menu page
Menu item select
Menu item select 
Menu item select
3.2Press CH+/- to select MANUAL SEARCH item. Press and hold VOL+ to search towards higher frequency; or press and hold VOL- to search toward lower frequency. When a channel is located, the searching stops and the channel is stored in the specified channel number.
You can also use BAND selection to quicken searching process if you know which band your desired program locates in. Press CH+/- to select BAND item, press VOL+/- to adjust. The band switches among UHF,
PROGRAM | 001 |
SKIP | OFF |
BAND | |
FINE TUNE |
|
MANUAL SEARCH |
|
AUTO SEARCH | - - - |
CH.SWAP | |
CH TYPE | NEWS |
SEL. | SET |
PROGRAM | 001 |
SKIP | OFF |
BAND | |
FINE TUNE |
|
MANUAL SEARCH |
|
AUTO SEARCH | - - - |
CH.SWAP | |
CH TYPE | NEWS |
SEL. | SET |
3.3Repeat step 3.1 and 3.2 if you want to store another program in other position number.
After you finish searching, you may press DSP or repeatedly press MENU button to exit.
12