Motorola DSR205 manual Replacing the Remote Control Batteries, Remote Energy Saver

Using Your Remote

Using the remote control press the Menu button to bring up the Menu screen on the receiver monitor (TV).

•Choose Options, choose Change System Settings.

•Choose Installation Settings.

•On the Installation Settings menu, choose Set Remote Control Address. Now follow the instructions on the Remote Control Address screen.

•If you have multiple receivers, you will have to change the address on each of them. Choose from following addresses: 0000, 0001, 0002, or 0003.

To program your remote control for each receiver, hold down the SAT key on the remote control until the light flashes. Once the light begins to flash enter the desired address.

Replacing the Remote Control Batteries

When the remote control batteries are worn out (discharged), the remote will stop working. Replace the batteries as soon as possible to retain your programmed codes. Once you remove the batteries from the compartment, you must replace them within two hours to retain your programmable features. The remote control for this unit may be powered by two AA batteries. Use only high quality, non- corrosive batteries designed for use in electronic equipment. Remember to replace both batteries at the same time. To replace the batteries:

-Remove the cover by pressing down the back panel indentation and removing the panel off the remote control.

-Position each battery in the battery compartment so that the flat base (-) is against the spring and so that the raised contact (+) is against the terminal. Make sure the batteries are securely seated. Replace the cover.

"Remote Energy Saver"

If you misplace your remote (i.e., it is stuck in your couch), and a key is inadvertently pressed, the remote will automatically turn itself off after three minutes.

DSR205 User Guide 15