Magnavox VRA641AT99 Automatic Channel Setup, Press the VCR button, then press the Menu button

Automatic Channel Setup 11

Although your VCR may automatically memorize the channels you receive when you turn it on for the first time, this function lets you set up channels again. Make each entry within one minute of the previous entry.

1

Press the VCR button, then press the MENU button.

SELECT , 9 CHOOSE >/OK

→VCR SET UP TUNER SET UP INITIAL SET UP

5 Wait for the VCR to set up channels.

1

CBL / DBS TV VCR

VCR/TV POWER EJECT

QUICK PROGRAMMING

TO END PUSH EXIT

2

Press the PLAY 8 or STOP 9 button to select TUNER

SET UP, then press the FF :/OK button.	2-4
SELECT , 9 CHOOSE >/OK
→ CABLE/ANTENNA CABLE
AUTO CH. PROGRAMMING
ADD/DELETE CH.

1

TO END PUSH EXIT

3

Press the FF :/OK button repeatedly so that ANT (if you have an antenna) or CABLE (if you have a cable connection) appears beside CABLE/ANTENNA.

4

Press the STOP 9 button to select AUTO CH. PROGRAMMING, then press the FF :/OK button. AUTO CH. SET PROCEEDING PLEASE WAIT and a scale that shows the progress of channel setup will appear on the screen. The VCR will memorize all the channels you receive.

1	+	2	+		3
START	.............	STOP	.............	DATE
4	-	5	-		6
DBS		DAILY		WEEKLY
7		8			9
SPEED		0		CLEAR
	STILL/SLOW
...-		........			+
REW					FF
		PLAY
					/OK
		STOP
VOL		MENU			CH
	EXIT/STATUS
		TIMER
SKIP SEARCH		INDEX			AUDIO/MUTE
SMARTPICTURE					REC /OTR

5

Wait for a few minutes while the VCR sets up channels. When programming is complete, AUTO CH. SET COMPLETED will appear on the screen. Then, the programming of the lowest channel number placed in the VCR’s memory will appear on the screen. Now when you press the CH(annel) 8/9 button, you will scan only through channels you receive.

Helpful Hint

•The two Line Input modes will always be stored in the VCR’s memory at channel 00. To select A/V IN FRONT or A/V IN REAR, press 0,0, then press the CH(annel) 8/9 button so that A/V IN FRONT or A/V IN REAR appears on the screen briefly. To exit Line Input mode, use the CH(annel) 8/9 button to select a channel other than 00.