Under Conﬁgure IPv4, select Manually | Linksys KiSS 1600 specs

2b. On the Macintosh, go to System Preferences and select Network. Click on Conﬁgure, go under the TCP/IP Pane.

Under Conﬁgure IPv4, select: Manually.

3.Enter the IP Address below: IP Address: 192.168.1.1 Subnet Mask: 255.255.255.0

4.Plug your KiSS 1600 into the electrical socket to start it.

5.Wait up to 20 seconds for the KiSS 1600 to start loading. During this period, the display will remain black until the message “PLS WAIT” appears. Wait another 20 seconds for loading to complete.

6.When loading is ﬁnished, the message “NO NET” is displayed on the KiSS 1600.

7.Proceed to the Quick Setup to ﬁnish setting up your player. See Chapter 6 of this user guide. Make sure that you select WIRED NETWORK at the end of the Quick Setup.

8.Press SETUP on your remote control, and go to NETWORK SETTINGS, select NETWORK PROTOCOL, and turn off DHCP by selecting NO.

9.Enter the following addresses:

IP Address: 192.168.1.2

Netmask: 255.255.255.0

Gateway: 192.168.1.1

Primary DNS: 192.168.1.1

Secondary DNS: 0.0.0.0

Press OK to exit.

Your player is now connected to your computer.

10.Accessing your computer ﬁles is described in the Media Server chapter of this user guide.

11.If you experience a problem whilst connecting, check your cables or the FAQ on our website (www.linksys.eu; select your country, then Support, Technical Support and Easy Answers).

Setting up your WIRED connection at a later stage

If you decide to set-up your wired connection at a later stage, proceed as follows:

1.Connect your player using one of the methods described above

2.Start your KiSS 1600.

3.Press SETUP on your remote control to access the SETUP MENU.

4.Go down to NETWORK SETTINGS.

5.Select NETWORK INTERFACE, then select WIRED NETWORK.

6.Your player should be connected.

7.If you experience a problem whilst connecting, check your cables or the FAQ on our website (www.linksys.eu; select your country, then Support, Technical Support and Easy Answers).

WIRELESS CONNECTIONS

WIRELESS Connection using a router or an access point

Equipment required

•A wireless router with a built-in switch or an access point and a separate switch/hub.

•A Windows PC or a Macintosh with a wireless card. The Computer can also be connected to the wireless router via Ethernet (wired).

Step-by-Step Guide

1.Check that your Internet connection or home network is currently working with your computer. If you experience a problem with your Internet connection, contact your ISP (Internet Service Provider).

2.If it is not already connected, connect your Computer to the wireless router or to an external wireless access point that is connected to the router.

3.Deploy the player’s antennas (for better reception)

4.Plug your KiSS 1600 into the electrical socket to start it.

5.Wait up to 20 seconds for the KiSS 1600 to start loading. During this period, the display will remain black until the message “PLS WAIT” appears. Wait another 20 seconds for loading to ﬁnish.

6.Proceed to the Quick Setup to set up the wireless connection to your player. See Chapter 6 of this user guide.

7.If you experience a problem during connecting, check the FAQ on our website (www.linksys.eu; select your country, then Support, Technical Support and Easy Answers).

Linksys KiSS 1600 manual Under Conﬁgure IPv4, select Manually, Your player should be connected