Connections, Playback Modes, Program Playback

PLAYING DISCS


The battery compartment is located on the rear of the remote
control.
• Remove the battery compartment door by pressing in on the		– +
•	tab and removing the door.
•	Insert two (2) AAA size batteries into the battery compartment
	as shown to the right. Be sure to observe the polarity markings
	which are engraved inside the battery compartment. If the
	batteries are inserted incorrectly, the remote control will not
		+ –
	operate.	+ –
• Replace the battery compartment door.
	BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1.	Use only the size and type of batteries speciﬁed.
2.	Be sure to follow the correct polarity when installing the batteries as indicated in the battery
3.	compartment. Reversed batteries may cause damage to the device.
3.	Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh
4.	ones.
4.	If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury

Connection DVD to TV

CONNECTIONS

NOTE: When connecting the system cables, turn off the power and make certain the AC cord has been removed from the wall outlet. See figure in previous column.

Compatible Discs

This DVD player is capable of playing the following types of discs: DVDs, DVD+/- R, DVD+/- RW, Audio CDs, CD/CD-R/RW with MP3 files and Kodak Picture CDs. Before you insert a disc in the player, make sure it is compatible.

You can’t play the following types of discs: Laser Discs, CD-I, CD-ROM (computer discs), DVD-ROM or discs recorded using other broadcast standards (i.e. PAL or SECAM) or CD-G discs.

KODAK PICTURE CD

PLAYBACK MODES

Repeat Playback

While the disc is playing, press REPEAT button repeatedly to select a play mode: DVD play modes: Chapter repeat, Title repeat, ALL, off

CD play modes: Track repeat, All track repeat, off

MP3 Mode: Track repeat, All repeat, off

A-B Repeat

While in the Playback mode, press the Repeat A-B button to define where you want the section to start. Press the Repeat A-B button again to define where you would like the section to end, the unit will then play the selected area continuously.

Press the Repeat A-B button again to cancel A-B Repeat mode.

PROGRAM PLAYBACK

from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.
(Follow battery manufacturer’s directions.)
LOCATION OF CONTROLS
FRONT	1.	Power Button
	2.	Power/Standby
	3.	Indicator
	3.	Disc Compartment
	4.	Remote Sensor
	5.	PLAY/PAUSE ®p
		Button

1. Connect the Left and Right audio cables to the Left and Right AUDIO OUT jacks on the
	rear of the DVD player. Connect the other ends to the Left and Right IN jacks on the TV.
2.	You can also use the Coaxial Digital Out as described below.
2.	Connect the video cable (Select one of the following connections for video.)
	(GOOD) BASIC: Connect the video cable to the VIDEO OUT jack on the rear of the DVD
	player. Connect the other end to the VIDEO IN jack on the TV.
	(BETTER) S-VIDEO (not shown): Connect the S-Video cable to the S-VIDEO jack on

NOTE: Some discs may note be compatible due to laser pickup, recording formats and software used. Some technologies and methods used for MP3 file recording on CD- R/RWs can prevent optimal playback of these files by degrading the sound quality and/or the ability for the player to read the file.

Regional Coding

The region code for this DVD player is listed on the back of the player.

Select up to 20 Title/Chapters (or tracks for CD) to program play as follows:

1. Press the PROGRAM button; the program screen will appear.

2. Select the desired program number (best to start with 1), then press the Navigation button to select the Title column. Select the desired title number using the Navigation® ( , ) buttons, then press the ENTER button to select it.

3. Theπ †cursor will jump to the Chapter column. Select the desired chapter number using the Navigation ( , ) buttons, then press the ENTER button to select it.

4. You have now programmedπ † the first program. Repeat steps 2 and 3 to set more programs (up to 20). When finished, press the PLAY/PAUSE ( ) button to start

playback.®p

						6.	STOP X Button
						7.	OPEN/CLOSE Button
						REAR
						8.	Video Output Jack
						9.	Coaxial Digital Audio
							Output Jack
REAR	1	2	3	4	5 6 7	10. Audio Right/Left
REAR							Output Jacks
							AV Cable Part No.
							OS-8Z122zzz3-zz*
						11. Component Video (Y,
							PB, PR) Output Jacks
						12. S-Video Output Jack
						13. AC Power Cord
	8	9	10	11	12	13

REMOTE

the rear of the DVD player. Connect the other end to the S-VIDEO jack on the TV.

(BEST) PROGRESSIVE (Y, PB, PR) VIDEO OUT:

Use these jacks to connect to a TV with progressive video input

jacks, press the HDMI/PS button to select the compatible resolution

of the TV. Progressive scan is a video scanning system that

displays all lines in a frame in one pass, as opposed to the

traditional system, interlaced scan. This connection provides

optimum quality. To ensure maximum picture quality, use three Component Video Cables

video-grade cables for connections. Note that it is essential to

match the color-coded connectors with a compatible TV.

Connecting the DVD to a Home Theater System

1. Front Left Speaker

2. Television

3. Centeron top orSpeaker–below thecanTelevision.be located

BASIC PLAYBACK OPTIONS

DVD/CD BASIC OPERATION

1. Plug the power cord into the outlet once the DVD player is connected to your TV.

2. Turn on the TV and tune to its Video Input Channel, if necessary.

3. Press the POWER button to turn on the unit; the On/Standby indicator will turn green.

4. Press the OPEN/CLOSE button to open the disc tray. Insert a disc with the label side

facing up on the disc tray. Press the OPEN/CLOSE button again to close the tray; playback will start automatically.

5. If the Menu appears, use the Navigation (√, ®, π, †) buttons to select the desired option and press the OK button to select it.

6. To stop playback, press the STOP (X) button. Because the unit will remember where you stopped (not applicable in CD mode), simply press the PLAY/PAUSE ®p button to resume playback where you left off (resuming playback). If the STOP (X) button is pressed twice, the unit will stop completely. If the player is left in Stop/Pause mode for more than ten minutes without any user interaction, the screen saver will activate if the Screen Saver menu option is set to ON. There is no resume function when playing CDs.

SEARCH: During playback, press the Search ®® or √√ button to move the disc forward or backward at double (x2) speed to locate a specific section. Repeatedly press and the speed will increase to x4, x8, x16, x32 and resume normal playback.

ADVANCED PLAYBACK OPTIONS

ANGLE MARK: While in the Playback mode, press the ANGLE button; the total number of angles will appear on the screen. Repeatedly press the ANGLE button to select the desired angle; the angle will change in one to two seconds.

This is not available on all discs.

AUDIO (DVD): Press the AUDIO button repeatedly to change the audio language. This feature is not available on all discs.

Note: This option is only available if the disc offers a number of languages or formats.

MUTE: To temporarily mute the playback sound, press the MUTE button.

SUBTITLE MENU: Press the SUBTITLE menu button to select a subtitle language and to turn the subtitle menu on/off if your subtitle feature is available on the disc. TITLE MENU: To display the title menu if available on the disc, press the TITLE menu button. Then use the Navigation ( , , , ) buttons to select your desired option and press PLAY/PAUSE ®p button. √ ® π †

OSD BUTTON: Each press of the OSD button will display the elapsed time and remaining time of a playing disc. Each press of the OSD button will cycle through, depending on the playback mode as follows:

DVD

1 2

11 4 5

3 24

6 25

4. Sub-woofer–can be located anywhere in the room.

5.Front Right Speaker

6.Viewing/Listening Position–The best listening position is obtained by positioning the chair, sofa, etc. in the middle of all the speakers.

7.Rear Left Speaker

8.Rear Right Speaker

9.AV Amplifier w/Dolby Digital Decoder/DTS Decoder

The disc will move forward or backward at high speed until you press the PLAY/PAUSE ®p button; normal playback will resume at that point.

PAUSE: Press the PLAY/PAUSE ®p button while in the Play mode to pause the picture. To resume normal playback, press the PLAY/PAUSE ®p button.

SKIP: Press the Skip (n) button to advance the disc to the begi nning of the next chapter/track. Press the Skip (M) button to move the disc to the beginning of the previous chapter/track.

ZOOM: Press the SLOW/ZOOM button once during Normal or Still playback modes, and the unit will zoom x2. Press once more and the unit will zoom x4. Use the Navigation

1st press	Title Elapsed Time	Single Elapsed Time
2nd press	Title Remaining Time	Single Remaining Time
3rd press	Chapter Elapsed Time	Total Elapsed Time
4th press	Chapter Remaining Time	Total Remaining Time
5th press	Audio Mode	Off
6th press	Off

MP3: The OSD button does not do anything when an MP3 disc is inserted.

PLAYBACK OF AN MP3

7 8

0/10 10+

9 26

Place the subwoofer, front, rear and center speakers in locations as shown/described here. After correctly positioning the speakers, perform the Tone Test on the AV Amplifier and adjust the volume controls until the desired sound is achieved. For best results, sit in the viewing position and have someone adjust the volumes for you; this will enable you to set the optimal levels.

(√,®,π,†) buttons to move the image on the TV screen. Press the SLOW/ZOOM button once more to cancel the zoom function. This is not available on all discs.

SLOW FORWARD: Press and hold the SLOW/ZOOM button to activate Slow motion. Repeatedly press and hold to move the DVD forward in slow motion speeds of 1/2, 1/4, 1/8, 1/16, 1/32 and resume normal playback . The sound will be muted. Press the

PLAY/PAUSE button to resume normal playback.

PLAYING AN MP3

MP3 is an audio file format which compresses recorded music. The main advantage of

the mp3 format is the ability to store CD - quality music tracks on a personal computer

in user-friendly, compressed files.

1.	POWER Button	12.	10+ Button
2.	MENU Button	13. PROGRAM Button
3.	TITLE Button	14.	ANGLE Button
4.	Skip (n) Button	15.	OPEN/CLOSE Button
5.	Skip (o) Button	16.	SUBTITLE Button
6.	Navigation (π) Button	17.	GOTO Button
7.	STOP (X) Button	18.	SEARCH (M) Button
8.	OK Button	19.	SEARCH (l) Button
9.	Navigation (√) Button	20.	P/N Button
10.	SETUP Button	21.	Navigation (®) Button
11.	Number Buttons (0-10)	22.	Navigation (†) Button

REMOTE PART NO. 2B-2D081J01B-76*

BATTERY COVER PART NO. 2B-2D081J01B-76RBD* *Consumer Replaceable Part (See end of manual to order.)

23.VIDEO Button

24.PLAY/PAUSE Button

25.AUDIO Button

26.MUTE Button

27.REPEAT Button

28.Repeat A-B Button

29.SLOW/ZOOM Button

30.OSD (On Screen Display) Button

NOTES FOR CONNECTING TO A TV:

• If your TV has a Component Video input, connect the DVD player with the component cable for best results, otherwise use the S-Video or Video OUT jack on the DVD player.

• Set the TV’s TV/VIDEO button or switch to the VIDEO setting.

• When connecting the DVD, refer to the owner’s manuals for the TV and the audio system, as well as this manual.

• When connecting, make sure the power is off and all units are unplugged before making any connections.

• Connect the DVD player to your TV directly. If you connect the DVD player through a VCR, the playback picture will be distorted because DVD video discs are copy protected.

• If using a TV with a blue screen option, turn the option off on the TV for best results.

• If you place the DVD player near a tuner, the radio broadcast sound might be distorted. In this case, move the DVD player away from the tuner.

®p

TITLE/CHAPTER/TIME SEARCH (DVD ONLY):
Press the GOTO button once.
Press the Navigation (√,®) buttons to select the title, then use the Number (0-9) buttons
to sel ec t the des ired ti tl e number. Then press			the OK but ton ; playback will
start immediately.	OR
Press the Navigation (√,®) buttons to select the chapter, then use the Number (0-9)
buttons to select the desired chapter number (i.e, for 12, press "1", "2"). Then press the
OK button; playback will start immediately.		OR
Press the GOTO button again, then press the Navigation (√,®) buttons to select the
tim e, th en us e	th e Num be r (0-9 )	butto ns	to sel ect the desi re d time

(Hour/Minutes/Seconds). Then press the OK button; playback will start immediately.

Before inserting a disc, check that it is compatible with the player:
1.	Press the POWER button to turn on the unit; the On/Standby indicator will turn
2.	green and open the disc tray by pressing the OPEN/CLOSE button.
2.	Place the disc in the tray with the printed side facing up and close the tray.;
3.	playback will start automatically.
3.	If you want to select a folder/track, then Press the STOP (X) button to stop
	playback.
	Select a folder using the Navigation (π, †) buttons, then press the OK button to
	see the folder’s contents.
	Select a track using the Navigation (π, †) buttons, then press the OK button to
4.	start playback.
4.	To go back to the folder list, press the Navigation (√) button.
5.	For Skip and Search functions, please refer to the basic playback options.
6.	Enter the track/file using the number buttons to directly select and playback a file.
	(i.e. For the 12th track, press "+10", "2" buttons.)
3

BATTERY PRECAUTIONS