Marantz DV4610 manual Connections, Description Rear Panel, V Euro Connector

CONNECTIONS

Description - Rear Panel

7 8 1 2 3 4 5 6

1.DIGITAL OUT Jacks

Use either an optical or coaxial digital cable to connect to an AV amplifier.

2.2CH AUDIO OUT Jacks

Connect to the Audio input jacks of your TV or Stereo system.

3.VIDEO OUT Jack

Use a video cable to connect the jack to the Video input jack of your TV or Stereo system.

4.COMPONENT VIDEO OUT Jacks

Use these jacks if you have a TV with Component Video input jacks. These jacks provide CR/PR, CB/PB and Y video. Component Video provides the best picture quality.

5.S-VIDEO OUT Terminal

Use the S-Video cable to connect this terminal to the S-Video input terminal of your TV for higher picture quality.

6.A/V EURO CONNECTOR

Connect to the 21-pin Scart jack of a TV.

7.REMOTE CONTROL IN/OUT Jacks

By connecting this DVD player to another Marantz audio component using a supplied Remote control bus cable, you can remotely operate the components as a signal system.

8.REMOTE CONTROL EXTERNAL / INTERNAL Switch

Set this switch to “INTERNAL” when using this DVD player independently. If you use this DVD player in a system with a Marantz receiver equipped with a remote sensor, set the switch to “EXTERNAL”.

NOTES:

•Be sure not to use both the A/V EURO CONNECTOR and COMPONENT VIDEO OUT jacks for video output at the same time.

•When changing the “VIDEO OUT” setting (“SCART”, “COMPONENT INTERLACE” or “COMPONENT PROGRESSIVE”), connect to a Video jack or an S-Video terminal on the TV. If the setting is changed, for example, to “COMPONENT INTERLACE” or “COMPONENT PROGRESSIVE” while the A/V EURO CONNECTOR is connected to the TV, a distorted video signal may be output.

•When connecting to a component with a remote sensor, be sure to connect the REMOTE CONTROL IN jack of this DVD player to the REMOTE CONTROL OUT jack of the component.

•When connecting to a component which is not equipped with a remote sensor, be sure to connect the component to the REMOTE CONTROL OUT jack of this DVD player.

Selecting Progressive Scan (625p <576p> or Interlaced 625i <576i>) Playback

•If your TV is compatible with progressive scanning (625p <576p>), connect the TV to the COMPONENT VIDEO OUT jacks of the DVD player and set “VIDEO OUT” to “COMPONENT PROGRESSIVE” in the display setting. Next, set your TV to the progressive scan mode.

Refer to pages 24-25 for instructions on changing the display setting.

•If your TV is not compatible with progressive scan, set “VIDEO OUT” to “COMPONENT INTERLACE”.

•Use a commercially available adaptor if the Video input jacks of your TVs or monitors are the BNC type.

What is Progressive Scanning?

•Unlike conventional interlace scanning, the progressive scan system provides less flickering and images in higher resolution than that of traditional (625i <576i>) television signals.

– 12 – EN