Krell Industries Connecting the DVD Standard to Your System, Using Balanced, Value in mind

Connecting the DVD Standard to Your System

USING BALANCED	Krell recommends using balanced interconnect cables. Balanced
CONNECTIONS	interconnect cables not only can minimize sonic loss but are also
	less sensitive to induced noise, especially with installations using
	long cables. Balanced connections have 6 dB more gain than single-
	ended connections. When level matching is critical, keep this gain
	value in mind.

Connection Steps

This section provides information about connecting your DVD Standard to other components in your system. The DVD Standard is equipped with a variety of connection options, for ease of integration into your home theater system.

Follow these steps to connect the DVD Standard to your system.

1.Make sure all power sources and components are off before connecting inputs and outputs.

2.Neatly organize the wiring between the DVD Standard and all system components. Separate AC wires from audio cables to prevent hum or other unwanted noises from being introduced into the system.

3.Connect the input of your video components to the appropriate output of the DVD Standard. See Getting Started, on page 6, for information on ensuring that your video monitor and settings are compatible with the DVD Standard.

4.Connect the balanced or single-ended analog outputs.

5.Plug the AC power cord into the IEC connector (37) on the back panel, then plug the AC power cord into the wall socket. The red stand-by LED (3) on the front panel illuminates.

Krell DVD Standard 25