Programming For VCR
Most GE, RCA and ProScan VCRs will not require programming. Check to see if your VCR responds to the remote before you begin programming.
1.Manually turn on the VCR. Find the three digit code for your VCR in the code list below.
2.Press and hold the CODE SEARCH button until the INDICATOR LIGHT lights, then release the CODE SEARCH button.
3.Press and release the VCR button (The INDI- CATOR LIGHT will blink then remain lit.
4.Enter the code using the Number Buttons. After your code is entered, the INDICA-
TOR
LIGHT will turn off. If the code is not valid, the
INDICATOR LIGHT will blink. Check the code list and repeat process.
SETUP
INDICATOR
|
|
| LIGHT |
| VCR |
| |
|
|
| (BLINK) |
1 | 2 | 3 |
|
4 | 5 | 6 |
|
7 | 8 | 9 | (OFF) |
| 0 |
|
|
|
| ON•OFF | |
CHAN +
5.Aim the remote at your VCR and press the ON•OFF button. Your VCR should turn off.
VCR CODE
NOTE: If your VCR does not respond, try all the codes for your brand. If the codes do not work, or your brand is not listed, try the Code Search method.
6.With your VCR on, press CHAN+ (CHANNEL UP). If the VCR responds, no further programming is required.
7.Enter your code here for easy reference.
6