Programming For DBS Satellite Sys.
Most GE, RCA and ProScan Satellite systems will not require programming. Check to see if your DBS Satellite system responds to the remote before you begin programming.
1.Manually turn on the DBS system. Find the three digit code for your DBS
system at the back of the instructions.
2.Press and hold the CODE SEARCH button until the INDICATOR LIGHT lights, then release the CODE SEARCH button.
3.Press and release the CBL/SAT button (The INDICATOR LIGHT will blink then remain lit.
4.Enter the code using the Number Buttons. After your code is entered, the
INDICATOR LIGHT will turn off. If the code is not valid, the INDI CATOR LIGHT will blink. Check the code list and repeat process.
5.Aim the remote at your DBS system and press the ON•OFF but ton. Your DBS system should turn off.
CODE
SEARCH
INDICATOR
LIGHT
CBL/SAT
|
|
| (BLINK) |
1 | 2 | 3 |
|
4 | 5 | 6 |
|
7 | 8 | 9 | (OFF) |
| 0 |
|
|
|
| ON•OFF |
CHAN +
6.With your DBS System on, press CHAN+ (CHANNEL UP). If the satellite system responds, no further programming is required.
NOTE: If your DBS system does not respond, try all the codes for your brand. If the codes do not work, or your brand is not listed, try the Code Search method on Page 12.
7.Enter your code here for easy reference.
SATELLITECBL/SAT CODECODE
9