Jasco RM24973 instruction manual Learning Function, Indicator Light blinks

Learning Function

The learning feature is used as a supplement to the stan- dard preprogrammed library. the standar code library provides most of the functions needed,, but you can add additional functions from your original remote. Note: No functions may be stored under the LEARN, SLEEP, SETUP, MENU or any of the device buttons.

1.Place the remote control unit and the original remote control unit so the

bottom end of the 2 inches 24973 remote (infrared

receiver) faces the top

end (infrared trans- mitter) of your orginal remote. They should

not be any more than 2 inches apart.

2.Press and hold the SETUP but- ton until the INDICATOR LIGHT lights, then release the SETUP but- ton.

3.Press and release the desired Mode button (TV, VCR, DVD, etc. . . .) The INDICATOR LIGHT will blink off once button press is accepted.

4.Press and release the LEARN button.

5.Press and release the button to be learned on this remote. Any button (except, LEARN, SETUP, MENU, OR device buttons) can be used to store learned functions.

6.Press and hold the button on the original remote control until INDICATOR LIGHT on this remote blinks once. Once the

INDICATOR LIGHT blinks

you may continue with the next function. If there is an error in learning the new function the INDICATOR LIGHT will flash for 3 seconds but remain in the learning mode. Return to step 5 if the INDICATOR LIGHT flashed.

NOTE: Hold the function key on your original remote for at least 3 seconds for the command to be successfully learned.

7.Repeat steps 5 and 6 to store more functions.

8.Once the selected functions are stored press the SETUP button and the remote will return to original operation mode.

9

BLINK