RCA F27TF12 manual Using the TV’s Features, PIP Picture-In-Picture Feature, How To Use PIP

Using the TV’s Features

The PIP (Picture-In-Picture) Feature

The PIP (Picture-In-Picture) feature lets you display a second, smaller picture on top of the main picture.

VCR1 ON•OFF TV

DVD VCR2 AUX SAT•CABLE

MUTESKIP

	CH +
VOL	VOL
	CH
SOUND	GO BACK

GUIDEINFO

OK

MENUCLEAR

1 2 3

4 5 6

7 8 9

INPUT		ANTENNA
0
REVERSE	PLAY	FORWARD
RECORD	STOP	PAUSE
PIP SWAP	CH CTRL RESET

The main PIP buttons (PIP, CH CTRL and SWAP) are at the bottom of the remote control.

How To Use PIP

While you can use PIP in different ways, this basic PIP scenario should get you started.

1.The TV must be on. Tune to the channel you want to watch.

2.Press the PIP button on the remote (the PIP picture appears with the same picture in it as the main picture).

3.To change the picture in the PIP window, press the CH CTRL button on the remote control and then press the channel up or down buttons.

4.To change the channel in the main picure, press CH CTRL again and then press the channel up or down button on the remote control.

.

PIP Buttons: General Explanation

The buttons on the remote control that you’ll use for the PIP feature are explained below:

PIP Press the PIP button to make the PIP window appear on the screen. Press PIP again to remove the window.

Right arrow button Moves the PIP window to different areas of the screen. Press and hold or just press.

CH CTRL (channel control) Lets you switch channel control between the PIP window and the main picture. To determine whether the remote control is the PIP picture or the main picture, look at the TV screen: the channel with the white circle next to it is the one you are controlling. Press CH CTRL to change which picture you’re controlling.

SWAP Switches, or “swaps,” where the two pictures appear on the TV screen. The smaller PIP picture swaps to the main screen and the main picture goes to

the little PIP window.

Note: Swap won’t work if the remote is in the wrong mode. For example, once you turn on the VCR with the VCR1 button, you can’t SWAP the pictures until you put the remote in TV mode. Just press the TV button.

22 Chapter 3

F27TF12.03 Features 22 7/19/01, 3:38 PM