Clarion AX430 owner manual Basic Operation

7. OPERATION

Note:

•Be sure to read this chapter referring to the front diagrams of chapter “2. CONTROLS” on page 3 (unfold).

Basic Operation

CAUTION

When this unit is turned on, starting and stop- ping the engine of a car with its volume raised to the maximum level may harm your hearing.

Be careful about adjusting the volume.

1)Press the [FNC] button.

*To turn the power off, press the [FNC] button for at least 1 second.

2)Press the [FNC] button to select the opera- tion mode. The mode switches as follows each time the [FNC] button is pressed:

Radio ➜ Tape ➜ CD changer ➜ Radio

Adjusting the Treble

1)Press [A-M] button and select “TREB”.

2)Turning the [ROTARY] knob clockwise empha- sizes the treble; turning it counterclockwise at- tenuates the treble.

*The factory default setting is “0”. (Adjustment range: –6 to +6)

3)When the adjustment is complete, press [A-M] button several times until the function mode is reached.

Adjusting the Balance

1) Press [A-M] button and select “BAL”.

*If a component is not connected, that opera- tion mode cannot be selected.

*“CASS” appears when no tape is loaded in the source unit, and “DISC” appears when no disc is loaded in the CD changer.

3)Turning the [ROTARY] knob clockwise in- creases the volume; turning it counterclock- wise decreases the volume.

*The volume level is from 0 (minimum) to 33 (maximum).

Audio Mode Adjustments

Press the [A-M] button to select the adjustment mode. The mode switches as follows each time the [A-M] button is pressed:

BASS ➜ TREB ➜ BAL ➜ FAD ➜ Previous mode

Adjusting the Bass

1)Press [A-M] button and select “BASS”.

2)Turning the [ROTARY] knob clockwise empha- sizes the bass; turning it counterclockwise at- tenuates the bass.

*The factory default setting is “0”. (Adjustment range: –6 to +6)

3)When the adjustment is complete, press[A-M] button several times until the function mode is reached.

8 AX430

2)Turning the [ROTARY] knob clockwise empha- sizes the sound from the right speaker; turn- ing it counterclockwise emphasizes the sound from the left speaker.

*The factory default setting is “0”. (Adjustment range: L9 to R9)

3)When the adjustment is complete, press [A-M] button several times until the function mode is reached.

Adjusting the Fader

1)Press [A-M] button and select “FAD”.

2)Turning the [ROTARY] knob clockwise empha- sizes the sound from the front speakers; turn- ing it counterclockwise emphasizes the sound from the rear speakers.

*The factory default setting is “0”. (Adjustment range: F9 to R9)

3)When the adjustment is complete, press [A-M] button several times until the function mode is reached.

Setting the Z-enhancer

This unit comes with three types of sound tone effects stored in memory. Select the one you pre- fer.

* The factory default setting is “Z-EHCR OFF”.

Each time you press [Z-EHCR] button, the tone effect changes in the following order.

“Z-ENHANCER 1” ➜ “Z-ENHANCER 2” ➜ “Z-ENHANCER 3” ➜ “Z-EHCR OFF” ➜ “Z-ENHANCER 1”...