Sony KV-27S40, KV-29SL40C, KV-29SL65C, KV-29XL40M, KV-29SL40A, KV-29XL40P Picture Tube Removal

KV-27S40 / 27S45 / 27S65 / 29SL40 / 29SL40A / 29SL40C/ 29SL45 / 29SL65 / 29SL65C/ 29XL40M / 29XL40P / 29XT11A

2-4. PICTURE TUBE REMOVAL

WARNING Before removing anode cap:

H.V. remains in the CRT even after the power is disconnected.

To avoid electrical shock, discharge CRT before attempting to remove the anode cap : Short between anode and CRT coating earth ground strap.

E board

Chassis assy

Coating earth ground strap

Degaussing coil

C board

K board

(KV-27S65/29SL65/29SL65C ONLY)

Neck assy

Deflection yoke

P board

(KV-27S45/27S65/29SL45/29SL65C/29SL65)

Four screws
(Tapping screw 7)	Tension spring (B)

Anode cap

Picture tube

Cushion

REMOVAL OF THE ANODE-CAP

NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after removing the anode.

REMOVAL PROCEDURES

Turn up one side of the rubber cap in	Use your thumb to pull the rubber cap
the direction indicated by arrow .	firmly in the direction indicated by
	arrow .

HOW TO HANDLE AN ANODE-CAP

Do not use sharp objects which may cause damage to the sur- face of the anode-cap.

Do not squeeze the rubber covering too hard to avoid damag- ing the anode-cap. A material fitting called a shatter-hook ter- minal is built into the rubber.

Do not force turn the foot of the rubber cover. This may cause the shatter-hook terminal to protrude and damage the rubber.

When one side of the rubber cap sepa- rates from the anode button, the anode- cap can be removed by turning the rub- ber cap and pulling it in the direction of arrow .

— 23 —