Sony KV-27HSR10 Ohmcoaxial cable roundI Attach an optional F-typeconnector, Cable, Fasten with a

Page 10

Either an indoor antenna or outdoor antenna can be connected. For better quality picture, connecting an outdoor antenna is recommended.

iin

Im Check the cable type and prepare the cable

• end using the appropriate connector.

75-ohmcoaxial cable (round)I

Attach an optional F-typeconnector.

1

7 mm (1/4inch) 10 mm (3/8 inch)

F-typeconnector

2

3 mm (1/8inch)

3

4

I 300-ohm twin.leadcable (flat) r

Attach the suppliedantenna connector.

 

screwdriver.

_

Loosen with a

3

Attach the

cable and

 

 

fasten with a

 

screwdriver.

*Most combination antennas are equipped with a signal splitter, Remove the splitter and attach the appropriate connector,

Cable TV reception is only possible by connecting a cable supplied by your local cable operator.

p,_

lug the connector into VHFIUHF on the

 

rear of the TV.

] 75-ohm coaxial cable (round) I

VHF/UHF

300-ohm twin-leadcable (flat) ]

VHF/UHF

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents KV-27HSR10 Ecaution Adjusting the picture ConnectingConnecting Other equipment Presetting TV channels Watching SettingSupplied Remote Commander Provides you many other convenient featuresSafety Installation Cleaning RepackingRefer to the pages indicated in for details VHFlUHF antenna terminal AUX auxiliaryterminalTo CONVERTERterminal Video 1, 2, 3 in jacks p/normjacksWindow audio and video adjusting buttons CH channel scan buttons RVOL volume control buttonsBattery life Cable Ohmcoaxial cable roundI Attach an optional F-typeconnectorAttach Fasten with aUhfvhf When you connect both VHF and UHF antennasWhen you connect both Vhfiuhf antennasand a Catv cable AUXMonitor OUT YC15VI30V-l ll Connecting VCRs with an S video output jackRear of TV YC-15V/30VPreparations OP tionalRear of TV To adjust sound levelSignal flow Amplifier For better soundPage Auto PGM PowerTo check preset channels Receivable channels of this TV areTo add channels --Press ADD To erase channels-- Press EraseT U V W Select a channel in one of the following two ways EnterTo turn off the unit Ing quickly two channels SRSReceMng a Multichannel IVSound program You can adjust the picture and sound levels and have Rx opetio seethe rxt pagesHUE Color To adjust picture contrastTrinitone LOW Trinitone High Sharp sharpness NOTCHiTrinitone Video BrightAudio ResetBalance AudioJide Press Guide Press +/- until the desired day of the week appearsPress0-9 to set the desired time. For 530, press 0,5,3,0 Press EnterPress +1- to set AM or PM To clear the current time settingTo reset the setting Press ENTER. startGuide Repeatedly until ON/OFF Timer turns PressPress 0-9 to set the desired time For 100, press 0,1,0,0 Press 0-9 to set the desired channel number EnterTo clear the setting Input Check and Adjust SymptomGood picture, no sound
Top Page Image Contents