Sony KV-27HSR10, KV-32HSR10 manual Good picture, no sound, Symptom, Check and Adjust

Page 32

Disturbances in picture and sound can often be eliminated by checking the symptoms and following the suggestions listed below.

SYMPTOM

Poo_ or no picture (Screen not lit), good sound

Good picture, no sound

No picture (screen not lit), no sound

No color

Snow and noise

only

CHECK AND ADJUST

•Adjust PICTURE.

•Adjust BRIGHT.

•Check antenna/cable connections.

•Press VOLUME + on the TV or VOL + on the Remote Commander.

•Press MUTING on the Remote Commander.

•Check that the MTS button is set correctly.

•Check that the TV/VIDEO button is set correctly.

•Set the SPEAKER SW (switch) to ON.

•Is POWER switched on?

•Plug the unit into a wall outlet.

•Check that the TV/VIDEO button is set correctly.

•Is it a color program?

•Adjust COLOR.

•Is it an active or the correct channel?

•Check the CABLE setting.

•Check the ANT/AUX button setting.

•Check antenna/cable connections.

r		_	-	. _. € .	Dotted
	.,._-:2			. _. € .	Dotted
!m-_*_":_i'7' _"'I					lines
,		_		_ _	or
i _' [ _"_"_UJ					or
t ,, _'_,4_-- _					stripes
I		_			Double
				'_	orimagesghosts

This is often caused by local interference. (e.g. cars, neon signs, hairdryers etc.) Adjust antenna for minimum inter- ference.

Reflections from nearby mountains or buildings often cause this problem.

A highly directional outdoor antenna or a CATV cable

may improve the picture.

Try another channel. It could be station trouble.

If the problem persists, contact your nearest service facility.

Sony Corporation Printed in U.S.A

Image 32

Contents KV-27HSR10 Ecaution Connecting Connecting Other equipment Presetting TV channels WatchingAdjusting the picture SettingSupplied Remote Commander Provides you many other convenient featuresSafety Installation Cleaning RepackingRefer to the pages indicated in for details AUX auxiliaryterminal To CONVERTERterminalVHFlUHF antenna terminal Video 1, 2, 3 in jacks p/normjacksWindow audio and video adjusting buttons CH channel scan buttons RVOL volume control buttonsBattery life Ohmcoaxial cable roundI Attach an optional F-typeconnector AttachCable Fasten with aWhen you connect both VHF and UHF antennas When you connect both Vhfiuhf antennasand a Catv cableUhfvhf AUXConnecting VCRs with an S video output jack Rear of TVMonitor OUT YC15VI30V-l ll YC-15V/30VPreparations OP tionalTo adjust sound level Signal flow AmplifierRear of TV For better soundPage Power To check preset channelsAuto PGM Receivable channels of this TV areT U V W To erase channels-- Press EraseTo add channels --Press ADD Select a channel in one of the following two ways EnterTo turn off the unit ReceMng a Multichannel IVSound program SRSIng quickly two channels You can adjust the picture and sound levels and have Rx opetio seethe rxt pagesTrinitone LOW Trinitone High To adjust picture contrastHUE Color NOTCHi TrinitoneSharp sharpness Video BrightReset BalanceAudio AudioJide Press +/- until the desired day of the week appears Press0-9 to set the desired time. For 530, press 0,5,3,0Press Guide Press EnterTo clear the current time setting To reset the settingPress +1- to set AM or PM Press ENTER. startPress 0-9 to set the desired time For 100, press 0,1,0,0 Repeatedly until ON/OFF Timer turns PressGuide Press 0-9 to set the desired channel number EnterTo clear the setting Input Good picture, no sound SymptomCheck and Adjust