RCA PSVR65 user manual Turn On the VCR, Set Up a Digital Satellite Receiver and/or Cable Box

Setting Up the VCR

Turn On the VCR

1.Press VCR1 on the remote.

The first time you turn on the VCR, the SETUP menu will appear. Follow the steps on the screen to automatically set-up a satellite receiver or cable box, set the time, auto channel search, and select some feature options.

■Press number button 1 on the remote to Begin setup. Proceed to Auto satellite receiver and/or cable box Setup.

■Press number button 2 on the remote to Cancel the setup.

If you choose not to use the SETUP menu, follow the steps below to manually set up the VCR so it will operate properly.

If the SETUP menu does not appear, or you prefer, you can manually select the SETUP menu. Each of these features may also be performed individually.

To manually select the SETUP menu.

■Press MENU¥PROG to display the VCR MAIN MENU.

■Press 5 to display the SETUP menu.

SETUP

The setup procedure will help you configure your VCR. Would you like to begin the setup procedure now?

1 Begin setup

2 Cancel

Set Up a Digital Satellite Receiver and/or Cable Box

The DSS and cable box setups allow the VCR to record programs from a compatible cable box and/or satellite receiver.

■The VCR will turn on a digital satellite receiver and tune it to the channel you want to record during timer recordings. Position the receiver above the VCR to receive the infrared remote signal. (See pages 6-7.)

■If your cable box can be controlled by remote, the VCR may be able to tune it to the channel you want to record during VCR Plus+ and timer recordings. Position the remote-controllable cable box on top of the VCR to receive the infrared remote signal. (See pages 4-5.)

Set Up a Digital Satellite Receiver

1.Satellite receiver not used: Press 2. Setup is not required.

Satellite receiver used: Press 1 to continue.

2.Press two numbers on the remote to enter the channel that your VCR receives signals from the receiver. Press 0 before a single-digit number. Valid numbers are 02 Ð 69. Channels 3 and 4 are typical selections; however, some satellite receiver models permit you to use a vacant UHF channel. Refer to your receiver ownerÕs manual for details.

If you connected your receiver to the VCR using the receiverÕs AUDIO/VIDEO OUT jacks, press INPUT to select VIDEO1 or VIDEO2.

Press CLEAR on the remote to correct an entry.

3.Press MENU¥PROG to proceed.

ÒThe VCR will now receive all signals from the DSS receiver onÓÐ Ð message appears.

SETUP

Would you like to set up the VCR to control a DSS receiver?

1Yes

2No

DSS SETUP

On what ANTENNA channel does the VCR receive signals from the DSS receiver?

--

Press 02-69 or INPUT

Press MENU to exit

11