Setting Up the VCR
Startup
3.Turn on the TV.
A.Turn on the TV.
B. If you used one of the basic hookups, tune the TV to the channel selected with the CH3 CH4 switch on back of VCR.
If you used one of the advanced hookups, tune the TV to the TVÕs video input. (See TV ownerÕs manual for details.)
4.Turn on the VCR.
A.Press VCR on the remote.
5.Place channels in the VCR’s memory.
The first time you turn on the VCR or after a power interruption, perform the AUTO CHANNEL SEARCH so that your VCR can locate the channels available through your signal typeÑcable or antenna. The signal type is automatically selected when you perform the AUTO CHANNEL SEARCH function. Also, if you change the signal type, you will need to perform AUTO CHANNEL SEARCH again.
A. Press MENU to display the VCR MAIN MENU on the
TV screen. If this menu does not appear:
¥Make sure TV is tuned to same channel as the CH3 CH4 switch on the back of the VCR or the TVÕs video input (refer to TVÕs manual).
¥Press VCR, then press MENU again.
¥If you use a basic hookup, check VCR indicator in display panel Ð it should be on. Press TV•VCR to turn it on.
¥Check the connections.
B. Press 3 to display the CHANNELS menu.
C. Press 1 to begin AUTO CHANNEL SEARCH.
The VCR automatically selects CABLE (cable TV) or ANTENNA. If you need to change the setting manually, press 3.
Wait until the channel numbers stop changing. This takes about one to two minutes. The TV will then tune to the lowest channel found. Pressing CHAN on the remote or CHANNEL on the VCR up or down will select only the active channels.
AUTO CHANNEL SEARCH
Now scanning channel 45
Press any key to cancel
VCR MAIN MENU
1 Timer Recordings
2 Set Clock
3 Channels
CHANNELS
1 Auto Channel Search
2 Add/Remove Channels
3 Signal Type: CABLE
0 Exit
8