Pioneer SH-DT510 manual Contact your service provider or system installer

Problem	Solution
(5) No video service.	(a) Scan this channel again by using "MANUAL
	SETUP" and see if the video service will
	come back.
	(b) Check with the local TV stations. Sometimes
	they are just testing new video services on
	their channels and the video service may stop
	every once in a while.
(6) Does not have all the	(a) Try "MANUAL SCAN" to scan these missing
channels available after	channels.
activating “AUTO SCAN” when	This is caused by unexpected frequency
first time installing the receiver.	offset. For instance, in Sunshine Coast
	Australia, channel 47 and 65 are transmitted
	on 662.625 and 788.625 MHz, 125KHz offset
	to the legitimate frequencies 662.5 and 788.5
	MHz. Likewise channel 9A in Tasmania.
	SH-DT510 can receive them by Auto Scan
	most times, but we suggest you use Manual
	Scan when first time installing the tuner. Once
	the signal is picked up by the receiver, all the
	transmission parameters will be stored in your
	receiver's memory so that the next time you
	can scan these channels using Auto Scan
	without any problem.
(7) Does not have all the	(a) Try "AUTO SCAN" to scan all the channels
channels available after using	in VHF & UHF bands.
“QUICK SCAN”.	(b) If you still cannot get some channels please
	use "MANUAL SCAN" to scan them one by
	one.
(8) Cannot lock signal by using	(a) Check and make sure the frequency you
“MANUAL SCAN”.	entered is exactly the center frequency of the
	wanted channel.
(9) No Teletext.	(a) Make sure the channel you are watching
	carries teletext information.
	(b) Press "TTX" button on the remote control to
	double check there's teletext data output.
(10) Cannot receive channels	(a) Enter into OSD menu and clean all channel
after moving the tuner between	memory.
cities.	(b) Re-scan the channel using AUTO SCAN,
(for instance from Melbourne to	QUICK SCAN or MANUAL SCAN.
Sydney)

1: Contact your service provider or system installer.

31