General Description
Installing Batteries in the Remote Control
Installing Batteries
Open the battery compartment
1 cover on the back side.
Battery
Cover
Insert two 1.5V AAA size batteries in
2 correct polarity. Don´t mix old or used batteries with new ones.
2xsize AAA 1.5V
3 Closed the cover.
Battery
Cover
Point the remote towards the remote control sensor of the wireless TV and use it within 7 meters.
Put the used batteries into the recyc- ling bin since it can negatively affect the environment.
External Connection
Connecting VCR
These instructions assume that you have already connected your TV to an antenna or a cable TV system. Skip step 1 if you have not yet connected to an antenna or a cable system.
VCR Rear Panel
|
|
|
|
|
|
| COAXIAL | OUT |
|
|
|
|
|
|
|
| Pr |
Video Cable (Not supplied) |
|
|
|
| IN | Pb | ||
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| Y |
|
|
|
|
|
|
|
| SERVICE PORT |
EARPHONE | PC | RF |
| IN |
|
| POWER INPUT |
|
OUT | AUDIO | VGA | VIDEO | R | L | HDMI | DC 12V |
|
IN | IN |
|
|
|
|
|
| |
The batteries shall not be eposed to ecessive heat such as sunshine
fire of the like.
External Connection
Antenna connection
Antenna input impedance of this unit is 75ohm. VHF/UHF 75ohm coaxial cable can be connected to the antenna jack directly, if the antenna cable is 300ohm parallel flat feeder cable, you need to use the 300ohm/75ohm converter to connect the antenna cable to the antenna jack. For details Please refer to the following drawing.
Antennas with 300 ohm flat twins Leads | Antennas with 75 ohm Round Leads |
Use a 75ohm - 300ohm converter
ANT IN
75ohm coaxial cable
300ohm coaxial cable
Antenna cable
Antenna feeder
7
Follow the instructions in Viewing a VCR or Camcorder Tape to view your VCR tape. Each VCR has a different back panel configuration.
When connecting a VCR, match the color of the connection terminal to the cable. We recommend the use of cables with a Ferrite Core.
1.Unplug the cable or antenna from the back of the TV.
2.Connect the cable or antenna to the ANT IN terminal on the back of the VCR.
3.Connect an RF Cable between the ANT OUT terminal on the VCR and the ANT IN terminal on the TV.
4.Connect a Video Cable between the VIDEO OUT jack on the VCR and the VIDEO IN jack on the TV.
5.Connect Audio Cables between the AUDIO OUT jacks on the VCR and the AUDIO L and AUDIO R jacks on the TV.
If you have a mono
8