RCA PHD50300 manual Adjusting the Picture Settings in Memory Mode

The Menu System

Adjusting the Picture Settings in MEMORY Mode

In MEMORY mode, you can set and save the following picture adjustments:

CONTRAST – Changes the picture’s contrast (between light and dark).

BLACK LEVEL – Makes the picture lighter or darker.

SHARPNESS – Changes the picture’s sharpness.

COLOR – Changes color density (video input only).

TINT – Changes picture tint (video input only).

COLOR TEMP – Changes the color tone.

NOISE REDUCE – (noise reduction)– Removes extraneous information from the signal to make the picture clearer.

NOTE: Only the contrast and brightness can be adjusted when a computer signal is used.

Once you have selected MEMORY mode, you can adjust the picture settings. For example, to change the contrast setting:

PICTURE QUALITY

CONTRAST
BLACK LEVEL
SHARPNESS
COLOR
TINT	R	G
PRESETS	:	MEMORY
COLOR TEMP.	:	NORMAL
NOISE REDUCE :		LOW
SEL.	ADJ.	RETURN

This is the PICTURE QUALITY menu with the PRESETS option highlighted.

1.Use the ▲ or ▼ button to highlight the CONTRAST option. Press the

button to select it. The CONTRAST window appears. Use and

buttons to adjust the contrast.

NOTE: If you don’t push the or button within 5 seconds, the current setting is accepted and the previous screen reappears.

2.Once the contrast is adjusted, press OK or MENU. The contrast is set and you are returned to the PICTURE QUALITY menu.

3.Use the same procedure to adjust the black level and sharpness settings.

4.When you are finished adjusting the picture settings, press GO BACK to return to the main menu or press CLEAR to exit the menu system.

If the “CONTROL NOT AVAILABLE” message appears when you are trying to change the picture settings, make sure the preset mode is set to MEMORY. You can only change picture settings in MEMORY mode. The other modes are pre-set and can’t be changed.

CONTRAST

This is the CONTRAST screen.

26 Chapter 6