RCA L52FHD2X48 You are having problems with the Hdmi Connection, Remote control doesn’t work

Page 44

You are having problems with the HDMI Connection.

•Make sure the HDMI or DVI component is turned on and the cables are firmly connected. If problems still occur, turn off your component and reconnect it. Reset the power by unplugging the power cord and plugging it back in.

•If you are tuned to the HDMI 1, HDMI 2, HDMI 3 or HDMI 4 INPUT and you’re receiving an Unusable Signal message onscreen, press the INFO button on the remote. If Acquiring Channel appears in the Channel Banner, the HDMI or DVI device isn’t responding. Contact the manufacturer of the HDMI or DVI device for further assistance.

•If you tune to the HDMI 1, HDMI 2, HDMI 3 or HDMI 4 INPUT and you see snow, the video goes in and out, or the video takes a long time to appear, your HDMI or DVI component is having trouble sending video information to the TV. Reconnect your device. Reset the power by unplugging the power cord and plugging it back in. If problems persist, try connecting the Y Pb Pr jacks if they are available or contact the manufacturer of the HDMI or DVI component for further assistance.

•If you have black bars on each side of your picture, the component you connected might have a switch or a menu option allowing you to change the picture quality output that will fix this. Choose either 720p or 1080i.

The Remote control doesn’t work.

•Something might be between the remote and the remote light sensor on the front of the TV. Make sure there is a clear path.

•The remote may not be aimed directly at the TV.

•The batteries in the remote may be weak, dead, or installed incorrectly. Put new batteries in the remote. (Note: If you remove the batteries, you may have to reprogram the remote to operate other component.)

You are experiencing problems with V-Chip/Parental Controls.

•If the rating limits don’t work, you must lock the settings. Go to the Main Menu (press MENU on your remote), select Parental Control, select Lock Parental Control.

I don’t remember my password and I want to unlock the TV.

•If you forget your password, turn the TV off. Simultaneously press and hold VOL DOWN on the side panel and CANCEL on the remote for 5 seconds. Next time you enter the Parental Control Menu, enter a new password.

What Else Can I Do?

If you’ve been through the Troubleshooting section and nothing has fixed your problem, try rebooting your TV. Note that after a reboot, you may need to run your TV through the setup process again. To do a reboot, unplug the power cord from the wall outlet or power strip. Keep your TV unplugged for about 5 minutes. Then plug in the TV and turn it on. See if the problem is fixed. If the problem remains, then please click on the Customer Support Menu at www.rca.com/television for updated FAQs or contact RCA Customer Support at the support number provided in your Warranty under How To Get Service.

44

Chapter 5 Other Information

Page 43 Page 45
Image 44
Page 43 Page 45
Contents User’s guide Important Information Model No. Serial No. Purchase Date Dealer/Address/PhoneImportant Safety Instructions Table of Contents Using the Remote Control Using the TV Menu Protect Against Power Surges Safety InformationAvoid Audio Interference Avoid Direct LightRemoving Table Stand Mounting Your TV to the WallWhat You Need to Know Obtain the SignalWhat You Need Choose Your Connections Jacks Used Cable Needed Go toComposite Video Connection Connecting a Component with Composite Video GoodConnecting a Component with Component Video Better Connecting a Component with Hdmi Best Component Video ConnectionConnecting a PC Component HDMI/DVI Connection BestViewing a PC PC ConnectionViewing the Picture from the Connected Component Turn on the TV Plug in the TVPut Batteries in the Remote Complete the Initial Setup Set the TV Location ModeComplete Channel Setup Set the Menu LanguageWhat To Expect Watching TV Analog ChannelsDigital Channels Changing ChannelsExplanation of Jacks in alphabetical order Side Panel Buttons Buttons and Other Jacks on Your TVSide Input Jacks Remote Control Buttons TV FunctionsDetermine If You Need to Program Remote Programming the Remote to Operate Other ComponentsInput Button Using Direct Entry Using a Manual Code SearchUsing Automatic Code Search Programming the RemoteModes of Operation Using the RemoteManual Reset Cable Codes Remote Code ListAudio Codes CD Codes DVDDVD/VCR Combo Codes DVR CodesHome Theatre in a Box Satellite TV Codes017 018 033 Autotuning Channel BannerParental Controls and V-Chip Chip US and CanadaChip Rating Screen US V-Chip TV RatingsBlocking Specific Content Themes US V-Chip Movie Rating LimitBlocking Canada V-Chip Ratings Block ChannelBlock Buttons Blocking Unrated/Exempt ProgramsFetch Feature Screen FormatsUsing the Menu System Sound MenuAdvanced Settings SAPAdvanced Setting Setup Menu Channel SetupChannel List Menu List and LabelsPreferences Parental Control Menu Time MenuConnecting a Component with USB or a USB Flash Drive USB MenuUSB Connection USB DeviceFrequently Asked Questions FAQs Troubleshooting TV Problems TV won’t turn onThere is no picture and no sound but the TV is on Sound is fine, but the picture is poor qualityScreen is blank Buttons on the side panel don’t workTV turns off unexpectedly TV turns on unexpectedlyYou are having problems with the Hdmi Connection Remote control doesn’t workYou are experiencing problems with V-Chip/Parental Controls Don’t remember my password and I want to unlock the TVCanadian English V-Chip Rating System Chip Rating ExplanationsUS V-Chip Rating System Canadian French V-Chip Rating System New LCD Televisions screen sizes 33 and larger TTE Technology, Inc. TTE Limited WarrantyAll LCD Models How State Law relates to this warranty What your warranty does not coverProduct Registration Limitation of Warranty For how long after purchase Your warranty does not cover damages which are caused by What your warranty does not coverHow Provincial law relates to this warranty If you purchased your unit outside of CanadaCare and Cleaning FCC Information
Top Page Image Contents