Chapter 1: Connections and Setup
VCR Connection
- To avoid picture noise (interference), leave an adequate distance between the TV and the VCR.
AWhen connecting with an antenna
1. Connect the Antenna out socket of the VCR to the Antenna input socket on the TV.
VCR
ANT IN |
|
| (R) AUDIO (L) VIDEO |
ANT OUT | OUT |
| IN |
| AUDIO IN | ANTENNA/ | DIGITAL AUDIO |
AV1 | (RGB/DVI) | CABLE IN | OUT(COAXIAL) |
VIDEO L R
AUDIO 
Rear panel of the set
2.Power up the VCR and Television.
3.Tune the TV to the channel output by the VCR. (typically ch.3 or 4.)
4.Refer to the VCR manual for operating instruc- tions.
AWhen connecting with an RCA cable - 22/26 inches
|
|
| VCR |
ANT IN |
|
|
|
|
| VIDEO | (L) AUDIO (R) |
ANT OUT | OUT |
| |
| OUTPUT |
|
|
| SWITCH | IN |
|
|
|
|
| USB IN |
|
|
|
|
|
| VIDEO |
|
| AUDIO IN | ANTENNA/ | AV2 | L |
|
| AUDIO- | |||
| AV1 | (RGB/DVI) | CABLE IN | ||
VIDEO | L | R |
|
| R - |
|
| AUDIO |
|
|
|
Rear panel of the set Side panel of the set
1.Connect the AUDIO/VIDEO jacks between TV and VCR. Match the jack colors (Video = yellow, Audio Left = white, and Audio Right = red)
2.Insert a video tape into the VCR and press PLAY on the VCR.
3.Select the AV1 or AV2 input source using the INPUT button on the remote control.
4.Refer to the VCR manual for operating instruc- tions.
Chapter 1 | 23 |