Other Information
Can’t select certain channel
•Channel may be blocked or not approved in the Parental Controls menu.
•If using a VCR, check to make sure the TV/VCR button on the VCR is in the correct mode (press the TV/VCR button on your VCR).
•Press the WATCH TV button and then try to change channels.
Noisy stereo reception
•May be a weak station. Press the Sound button and choose Mono.
Black box appears on the screen
•
Problems with HDMI/DVI Connection
•Make sure the HDMI device is turned on and the cables are firmly connected. If problems still occur, turn off your device.
•If you are tuned to the HDMI input and you’re receiving No Signal message
•If you tune to the HDMI input and you see snow, the video goes in and out, or the video takes a long time to appear, your HDMI device is having trouble sending video information to the TV.
•If you have black bars on each side of your picture, the device you connected might have a switch or a menu option allowing you to change the picture quality output that will fix this. Choose either 720p or 1080i.
•480i signals aren’t supported by the HDMI input.
The Remote Control Doesn’t Work
•Something might be between the remote and the remote light sensor on the front of the TV. Make sure there is a clear path.
•Maybe the remote isn’t aimed directly at the TV.
•Maybe batteries in remote are weak, dead, or installed incorrectly. Put new batteries in the remote.
Problems with V-Chip/Parental Controls
I don’t remember my password and I want to unlock the TV
•If you forget your password, select Set Password from the Options menu and press OK. Press 3, 4, 4, and then 8. Then enter a new password you want to use.
The
•Maybe the movie was given an NR (Not Rated) status. After you block movie ratings, you must set NONE to View separately in order to view movies with an NR rating.
What Else Can I Do?
If you’ve been through the Troubleshooting section and nothing has fixed your problem, try rebooting your TV. Note that after a reboot you may need to run your TV through the setup process again. To do a reboot, unplug the power cord from the wall outlet, power strip, etc. Keep your TV unplugged for about 5 minutes. Then plug the TV back in, turn on the TV, and see if the problem is fixed. If the problem remains, then please visit www.rca.com/television for updated FAQs or contact RCA Customer Support at the support number provided in your Warranty under How To Get Service.
Chapter 4 | 31 |