¥Connect all devices before you plug any power cords into the wall outlet or power strip. NEVER plug your TV into an outlet that is controlled by a wall switch.
¥Turn off the TV and/or device(s) before you connect or disconnect any cables.
¥Make sure all antennas and cables are properly grounded. Refer to the Important Safety Instructions.
¥Protect devices from overheating.
¥DonÕt block ventilation holes on any of the devices. Arrange the devices so that air can circulate freely.
¥DonÕt stack devices.
¥If you place devices in a stand, make sure you allow adequate ventilation.
¥If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it wonÕt flow around other devices.
¥Insert each cable firmly into the designated jack.
¥If you place devices above the TV, route all cables down one side of the back of the TV instead of straight down the middle.
¥If your antenna uses
DonÕt place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirect lighting.
Check that the following parts were packed with your product.
Go to Page 8 to see the parts list for the table
stand
Graphics contained within this publication are presentation only.
Connections and Setup Chapter 1
7